Philips HR2020/70 User Manual download pdf (Page 9)

Storage

Note: Make sure the blender is clean and dry when you store it.

1 To store the mains cord, wind it round the reel in the base of the motor unit (Fig. 6).

2 Screw the blade unit anticlockwise onto the bottom of the blender jar.

3 Turn the blender jar upside down.

4 Put the blender jar on the motor unit.

Note: Make sure the handle of the blender jar is at the back of the motor unit.

5 Place the lid on top of the blender jar (Fig. 7).

Disposal

Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the

environment (Fig. 8).

Guarantee and service

If you need information or if you have a problem, please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Customer Care Centre in your country, go to your local

Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal

Care BV.

Troubleshooting

Problem Solution

The appliance does not

work.

Check if you have plugged in the appliance. Also check if the blender jar

is properly attached.

The motor produces

an unpleasant smell

during processing.

It is common for a new appliance to give off an unpleasant smell or

emitsome smoke the rst few times it is used. This phenomenon stops

after you have used the appliance a few times. The appliance may also

give off anunpleasant smell or emit some smoke if it has been used too

long. In this case switch off the appliance and let it cool down to room

temperature.

The appliance

stopsrunning because

theblade unit is

blocked.

Switch off the appliance and use a spatula to dislodge the ingredients

that block the blade unit. We also advise you to process a smaller

quantityand/or to cut ingredients into smaller pieces before you put

them in theblender jar.

The blender jar leaks. Switch off the appliance and pour out the ingredients. Then remove the

bladeunit. Check if the sealing ring is assembled properly on the blade

unit.

-

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments