Philips SCD499 User Manual download pdf (Page 14)

Make sure the parent unit is dry before you put it back into the charger.

3 Clean the charger with a dry cloth.

Storage

You can use the travel pouch to store the baby monitor while you travel.

When you are not going to use the baby monitor for some time, remove the batteries and

store the parent unit, the baby unit, the adapter of the baby unit and the charger in the travel

pouch supplied.



Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the

environment (Fig. 34).

Batteries contain substances that may pollute the environment. Do not throw

away batteries with the normal household waste, but hand them in at an ofcial collection

point. Always remove the batteries before you discard and hand in the appliance at an ofcial

collection point.



If you need information or if you have a problem, please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Customer Care Centre in your country, go to your local

Philips dealer or contact the Service Department of Philips Domestic appliances and Personal

Care BV.



This chapter lists the questions most frequently asked about the appliance. If you cannot nd the

answer to your question, contact the Customer Care Centre in your country.

Question Answer

Why don’t the ON light

of the baby unit and the

LINK light of the parent

unit come on when I

press the on/off buttons

of the units?

Perhaps the batteries of the parent unit are empty and the parent

unit is not in the plugged-in charger. Put the adapter of the charger in

the wall socket and place the parent unit in the charger. Then press

the on/off button to establish connection with the baby unit.

Perhaps the batteries of the baby unit are empty and the baby unit is

not connected to the mains. Replace the batteries or put the small

plug in the baby unit and put the adapter in a wall socket. Then press

the on/off button to establish connection with the parent unit.

The baby unit and the parent unit may be out of range of each other.

Move the parent unit closer to the baby unit, but not closer than 1

metre/3 feet.

If the LINK light on the parent unit still does not start to ash, use

the reset function to reset the units to their default settings.

ENGLISH14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 207 208

Comments to this Manuals

No comments

Philips SCD499 User Manual Page 14

Comments to this Manuals

Related products and manuals for Baby Monitors Philips SCD499