Philips SCD499 User Manual download pdf (Page 11)

Lullaby function

1 Briey press the lullaby button K on the baby unit to select one of the ve lullabies

available. (Fig. 23)

2 Briey press the play/stop button E to play the selected lullaby. (Fig. 24)

3 Briey press the OK button on the parent unit to interrupt the lullaby. Press the OK button

on the parent unit again to continue the lullaby (Fig. 25).

If you do not continue the lullaby within 60 seconds, the lullaby function switches off

automatically.

4 Briey press the play/stop button E on the baby unit again to stop the lullaby. (Fig. 24)

Note:If you press the lullaby button K too long, no lullaby is selected.



If the batteries of the parent unit are sufciently charged, you can take the unit with you inside and

outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it

round your neck with the neck strap. This allows you to monitor your baby while you are moving

around.

Connecting the belt clip

1 Insert the small pin on the back of the belt clip into the opening on the back of the parent

unit (1). Turn the belt clip to the left (2) until it locks into position (‘click’) (Fig. 26).

Disconnecting the belt clip

1 Turn the belt clip to the right (1) and take it out of the opening (2) (Fig. 27).



1 Insert the small pin at the end of the neck strap into the opening on the back of the parent

unit (1). Turn the neck strap to the left (2) until it locks into position (‘click’) (Fig. 28).



1 Turn the neck strap to the right (1) and take it out of the opening (2) (Fig. 29).

Reset function

This function allows you to reset the parent unit and baby unit to the default settings. You can use

this function if problems occur that cannot be solved by following the suggestions in chapter

‘Frequently asked questions’. You have to reset each unit separately.

1 Press and hold the on/off button 3 for 2 seconds to switch on the unit. (Fig. 11)

2 Then immediately press and hold the volume down (-) button until the message ‘Reset’ is

shown on the display (Fig. 30).

The unit has now been reset to the default factory settings.

Now do the same for the other unit.

Default settings

Parent unit

Loudspeaker volume: 1

Microphone sensitivity: 3

Sound alert: on

Temperature alert: on

‘Temperature low’ alert: 14°C

‘Temperature high’ alert: 30°C

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 207 208

Comments to this Manuals

No comments

Philips SCD499 User Manual Page 11

Comments to this Manuals

Related products and manuals for Baby Monitors Philips SCD499