Philips AC4012/10 User Manual download pdf (Page 12)

10

EN

7 Replace the

filters

The lter replacement light ( )

indicates the lters have to be replaced.

Note

• If you remove the front panel for lter

changing while the purier is switched

on, all lights on the control panel will

be o.

• Once the front panel is placed back to

the purier, all lights ash twice. Then,

the purier is o. Press the



button to

switch on the purier again.

Replace the NanoProtect

Activated Carbon lter

and the NanoProtect

lter

Note

• The NanoProtect Activated Carbon

lter and the NanoProtect lter are not

washable or vacuum cleanable.

Replace both the NanoProtect

Activated Carbon lter and NanoProtect

lter when the

light goes on. This light

will be on for approximately 2 weeks.

On the last day of the 2 weeks, the

purier beeps every 30 minutes to

inform you that the lter needs to be

replaced.

Note

• Insert the lters in the correct position.

• Make sure you place the lters in the

order of NanoProtect lter, NanoProtect

Activated Carbon lter, and nally the

pre-lter.

• Make sure that the side with the tag is

pointing towards you.

1 Switch o the purier and unplug it.

2 Place your ngers in the recesses

of the side panels and gently pull

the bottom part of the front panel

towards you. Lift the panel out of

the hooks at the top of the purier

(g b).

3 Remove the lters using the tag on

the lter. Take the lters by both

sides and gently deposit them into

the house hold trash bin (g s).

Note

• Do not touch the pleated lter surface,

or smell the lter as it has collected

pollutants from the air.

• Wash your hands after disposing of the

used lters.

4 Remove all packaging material

from the new lters (g d).

5 Place the new NanoProtect lter in

the purier rst (g t).

6 Then, place the new NanoProtect

Activated Carbon lter in the

purier (g u).

7 Place the pre-ler in the purier

(g f).

Note

• Make sure that the side with the two

projections is pointing towards you,

and that all hooks of the pre-lter are

properly attached to the purier.

8 To reattach the front panel, insert

the top hooks into the top of the

purier rst (1). Then, push the

panel against the body of the

purier (2) (g g).

9 Reset the NanoProtect Activated

Carbon lter and the NanoProtect

lter lifetime (see ‘Reset the lter

lifetime counter’).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 93 94

Comments to this Manuals

No comments