Philips Wake-up Light User Manual download pdf (Page 9)

3 To switch off the lamp, press the lamp on/off button again.

Setting the alarm

When you set the alarm, you choose an alarm time and the type of sound you want to wake up to.

The alarm is set when the alarm symbol is visible on the display. The light intensity slowly increases

to the selected level during the last 30 minutes before the set alarm time. The sound slowly

increases in 90 seconds to the selected level after the set alarm time.

Note: You can set the light intensity by pressing the light on/off button and then pressing the light intensity

+ or - button and you can set the alarm volume by pressing the volume increase or decrease button.

If you do not want to wake up to the lamp or to a sound, set the light intensity or volume level to OFF.

See sections ‘Using the lamp’ and ‘Radio/volume’ in this chapter.

1 Push the control lever down to the middle position to switch on the alarm (Fig. 13).

, The hour indication of the alarm time ashes (Fig. 14).

, To adjust the time, follow steps 2 to 5. If the alarm time is correct, just wait a few seconds.

2 Press the menu + or - buttons to select the hour (Fig. 9).

Note: You can only do this when the hour indication ashes. If this is not the case, push the control lever

up and down again to enter the alarm time mode. You can also set the alarm time in the menu. See

section ‘Menu functions’ in this chapter.

3 Press the SELECT button to conrm (Fig. 10).

, The minute indication of the alarm time starts to ash (Fig. 15).

4 Press the menu + and - buttons to select the minutes (Fig. 9).

5 Press the SELECT button to conrm or wait for a few seconds (Fig. 10).

, The appliance leaves the menu and the display shows the clock time.

The alarm time is now set.

Switching off the alarm

To switch off the alarm function, push up the control lever to the top position.

Note: The lamp stays on to light your room. You can switch off the lamp by pressing the light on/off

button.

Note: The alarm (sound and/or light) automatically switches off after 90 minutes.

Setting the alarm sound

See section ‘Menu functions’ above.

You can choose one of the following sounds:

- Radio (Fig. 16)

- Birds (Fig. 17)

- Beep (Fig. 18)

- Wind chimes (Fig. 19)

Snoozing

1 Push down the control lever to the bottom position when the alarm goes off (Fig. 20).

, The lamp continues to be on at the selected intensity level, but the alarm sound stops.

After 9 minutes, the wake-up sound is automatically played again.

Note: The 9-minute snooze time is xed. This time cannot be adjusted.

Note: If you push down the control lever with too much force, it may jump back to off position.

ENGLISH 9

4222_002_7572_2_DFU-Booklet_A5_v1.indd 9 11/29/2012 10:45:19 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 119 120

Comments to this Manuals

No comments

Philips Wake-up Light User Manual Page 9

Comments to this Manuals

Related products and manuals for Light therapy Philips Wake-up Light