Philips SRU7060/10 User Manual download pdf (Page 5)

4 Press and hold the Standby key of

the SRU 7060 briefly.

– The SRU 7060 now starts emitting all known

‘TV off’ signals, one by one.

Each time a code is sent, the light around the

Standby key lights up.

5 When your TV switches off (standby),

release the Standby key of the SRU 7060

immediately.

– The SRU 7060 has now found a code that

works on your TV.

6 Check if you can operate all functions on your TV with the SRU 7060.

• If this is not the case, you can redo the automatic setting.The

SRU 7060 will then search for a code that perhaps works better.

– After the SRU 7060 has run through all the known codes, the search

will stop automatically and the light will stop blinking.

– Automatic programming of a TV takes a maximum of 3 minutes.

For DVD, CD,VCR, AMP and STB this time is 2 minutes.

Manually setting the remote control

Example TV:

1 Turn on the TV manually or use the original remote control.

Tune in to channel 1.

2 Look up the brand of your TV in the

code list at the back of this manual. One or

more four-figure codes are shown for each

brand.

Note the first code.

Be careful! There are separate tables for TV,VCR,

DVD, etc.

On our website www.philips.com/urc you can directly select your device

typenumber to find the right code.

Make sure you use the codes from the correct table.

3 Select the device mode TV with the

SELECT key. Press the SELECT key until the

light around the Standby key lights up.

Instructions for use

English

1 2 3 4 5 6 7 8 9 10 ... 151 152

No comments

Philips SRU7060/10 User Manual Page 5