Philips FC8810/01 User Manual download pdf (Page 9)

4 Spiral pattern

In its auto cleaning mode, the robot uses these patterns in a fixed

sequence:z-pattern, random pattern, wall-following pattern, and spiral

pattern.

When the robot has completed this sequence of patterns, it starts moving in

Z-pattern again. The robot continues to use this sequence of patterns to

clean the room until the rechargeable battery runs low, or until it is switched

off manually.

If the robot detects a particularly dirty area during its cleaning run, it

switches to spiral mode and switches to turbo fan speed (FC8820 only) to

ensure thorough dirt removal.

Note: You can also select each mode individually by pressing the

appropriate button on the remote control or the pointer (FC8820 only). The

manually selected modes are only active for a couple of minutes. After that,

the robot switches back to auto-cleaning mode.

For more details, see chapter 'Using your robot', section 'Cleaning modes'.

How your robot avoids height differences

The robot has three drop-off sensors in its bottom. It uses these drop-off

sensors to detect and avoid height differences such as staircases.

Note: It is normal for the robot to move slightly over the edge of a height

difference, as its front drop-off sensor is located behind the bumper.

Caution: In some cases, the drop-off sensors may not detect a staircase or

other height difference in time. Therefore monitor the robot carefully the

first few times you use it, and when you operate it near a staircase or

another height difference. It is important that you clean the drop-off

sensors regularly to ensure the robot continues to detect height

differences properly (see chapter ' Cleaning and maintenance' for

instructions).

Before first use

Mounting the side brushes

1 Unpack the side brushes and place the robot upside down on a table or

on the floor.

2 Push the side brushes onto the shafts on the bottom of the robot.

Note: Make sure you attach the side brushes properly. Press them onto

the shaft until you hear them lock into position with a click.

English

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 161 162

No comments

Philips FC8810/01 User Manual Page 9