Philips FC8810/01 User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 162
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
Problem Possible cause Solution
The robot is moving in
circles.
The robot is in spot-cleaning
mode.
This is normal behavior. The spiral mode
can be activated when a lot of dirt is
detected on the floor for a thorough clean.
It is also part of the auto cleaning mode.
After approximately one minute the robot
resumes its normal cleaning pattern. You
can also stop the spiral mode by selecting
a different cleaning mode on the remote
control.
There is not enough room for
the robot to navigate towards
the docking station.
Try to find another place for the docking
station. See 'Installing the docking station'
in chapter 'Preparing for use'.
The robot is still actively
searching.
Give the robot around 20 minutes to return
to the docking station.
The robot cannot find the
docking station.
The robot was not started
from the docking station.
If you want the robot to return to the
docking station after a cleaning run, start it
from the docking station.
The robot beeps when it
is on the docking station.
You try to charge the robot
with the power switch is in off
position.
Press the power switch to switch on the
robot.
Error codes
Error code Possible cause Solution
E1 Wheels stuck Remove robot from the obstacle and press the
starts/stop button to resume cleaning.
E2 Top cover or dust
container not placed
properly
Place the dust container in and the top cover
on the robot properly. The error code
disappears from the display automatically.
E3 Bumper stuck Remove the robot from the obstacle. The error
code disappears from the display
automatically.
E4 Robot lifted from floor Put the robot back on the floor to make the
error code disappear.
E5 Color of floor too dark Place robot on a lighter area of the floor. Clean
the drop-off sensors.
Battery not inserted
properly
Read the instructions in ‘Inserting the
rechargeable battery into the robot’ in chapter
‘Before first use’.
E6
Charging error Check if the power switch is in ‘on’ position
when
the robot is on the docking station
28
English
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 161 162

Comments to this Manuals

No comments