Philips MCD299/98 Specifications download pdf (Page 21)

English

21

Basic Functions

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available

radio stations automatically.

First time setup/power up

1 When you turn on the main supply, "AUTO

INSTALL - PRESS PLAY" is displayed.

2 PressÉÅ on the system to start installation.

➜ "PLUG AND PLAY" .... "INSTALL" is

displayed, followed by "TUNER" and "AUTO".

➜ PROG starts flashing.

➜ All available radio stations with sufficient signal

strength will be stored automatically, starting

from FM and followed by MW band.

➜ When all the available radio stations are

stored or the memory for 40 presets are used,

the last preset radio station will be played.

To reinstall Plug and Play

1 In standby or demonstration mode, press and

holdÉÅon the system until "AUTO INSTALL

- PRESS PLAY" is displayed.

1 PressÉÅ again to start installation.

➜ All previously stored radio stations will be

replaced.

To exit without storing the Plug and Play

● Press 9 on the system.

➜ If you do not complete the Plug and Play

installation, the function will be restarted when

you next turn on the main supply again.

Notes:

– When the power is turned on, the disc tray may

open and close to initialise the system.

– If no stereo frequency is detected during Plug

and Play, "CHECK ANTENNA" will be displayed.

– During Plug and Play, if no button is pressed

within 15 seconds, the system will exit Plug and

Play mode.

Switching the system on/off

● Press STANDBY-ON B.

● Press DISC, USB, TUNER or AUX on the

remote.

➜ The system will switch to the selected source.

● Press LEFT ç or RIGHT ç on the front

panel (L ç or R çon the remote).

➜ The system will switch to the disc source.

To switch the system to standby mode

● Press STANDBY-ON B.

➜ The interactive sound settings, last selected

source and tuner presets will be retained in the

player’s memory.

Power-saving automatic standby

As a power-saving feature, the system will

automatically switch to Standby mode if you do

not press any buttons within 15 minutes after a

disc has stopped playing.

Sound Control

DBB and DSC sound features cannot be

activated at the same time.

DBB (Dynamic Bass Boost)

DBB enhances the bass response.

● Press DSC•DBB on the remote to enable/

disable DBB feature.

➜ Some discs might be recorded in high

modulation, which causes a distortion at high

volume. If this occurs, switch off DBB or reduce

the volume.

DSC (Digital Sound Control)

DSC provides a different type of preset sound

equalizer setting.

● Press and hold DSC•DBB on the remote

repeatedly to select: FLAT, POP, CLASSIC, ROCK

or JAZZ.

pg021-pg044_MCD299-98-Eng-B 2007.9.27, 13:0421

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Comments to this Manuals

No comments