3
English
EN
What's in the box
Check and identify the contents of the package:
1 Main unit (with a sleeve) 2 Remote
control
3 Trim plate 4 Rubber
cushion
5 Screw X 4 (M5x8mm) 6 Hexagon
head screw
7 Remote control battery 8 User manual
3 Install the car
entertainment system
Always follow the instructions in this chapter in sequence.
These instructions are for a typical installation. However, if
your car has different requirements, make the adjustment
accordingly. If you have any question regarding installation kits,
consult your local retailer.
g h
Note
•
This system is designed for negative ground (earth) 12V
DC operation only.
• Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
• To avoid short-circuit: before you connect, make sure
that the ignition is off.
• Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
• Make sure that all loose leads are insulated with
electrical tape.
• Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
• Make sure that all ground (earth) leads are run to a
common ground (earth) point.
• Use only the supplied mounting hardware for a safe
and secure installation.
• Improper fuses can cause damage or re. When you
need to change the fuse, consult a professional.
• When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
• Never connect speaker wires to the metal body or
chassis of the car.
• Never connect speaker wires with stripes to one
another.
Connect wires
Note
•
The ISO male connectors are not supplied.
• Make sure that all loose leads are insulated with
electrical tape.
• Consult a professional to connect wires as instructed
below.
• Before connection, check the car's wiring carefully.
1 Connect the ISO male connectors.
Comments to this Manuals