Philips CED1900BT User Manual download pdf (Page 8)

English

Mount into the dashboard

Note

•

Make sure that wires are correctly connected before

you mount the main unit into a car.

• If preset radio stations are lost when the ignition key

is turned OFF and then back ON, reconnect the red

leads crosswise to the yellow ones.

1 If the car does not have an on-board drive or

navigation computer, disconnect the negative terminal

of the car battery.

• If you disconnect the car battery in a car that has

an on-board drive or navigation computer, the

computer may lose its memory.

• If the car battery is not disconnected, to avoid

short-circuit, make sure that bare wires do not

touch each other.

2 Make sure that the car dashboard opening is within

these measurements:

• Since the unit cannot be used if the dashboard

opening's slant angle is above 20 degrees, make

sure that the horizontal slant of the car dashboard

opening is between 0 and 20 degrees.

182 mm

112 mm

5 mm

3 Remove the mounting sleeve with the supplied

disassembly tools.

4 Install the sleeve into the dashboard and bend the tabs

outward to x the sleeve.

• If the system is not xed by sleeve but by the

supplied screws, skip this step.

5 Slide the unit into the dashboard until a click sound is

heard.

6 Attach the trim plate.

7 Reconnect the negative terminal of the car battery.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

No comments

Philips CED1900BT User Manual Page 8