Philips SCD570/10 User Manual download pdf (Page 16)

Menu options

All functions can be operated on the parent unit, but some functions can also be operated on

the baby unit.

Menu operation - general explanation

Note: Menu functions can only be operated when a connection has been established between the baby

unit and the parent unit.

1 Press the MENU button to open the menu (Fig. 32).

, The rst menu option appears on the display.

2 Use the – and + buttons to select the desired menu option (Fig. 33).

Note: The arrow indicates in which direction you can navigate.

3 Press the OK button to conrm (Fig. 34).

4 Use the + and - buttons to select the desired setting.

5 Press the OK button to conrm.

, The new setting ashes once. The message ‘saved’ also ashes once and then disappears from

the display.

6 Press the MENU button again to exit the menu.

ECO mode

Note: You can only switch the ECO mode on and off in the menu of the parent unit.

You can use the ECO mode to reduce the energy consumption of the appliance. Monitoring your

baby from a small distance requires less transmission power and less electrical power

than monitoring your baby from a large distance. When you monitor your baby from a small

distance, you can activate the ECO mode. In the ECO mode, the appliance consumes

less energy, but still ensures that you can always hear your baby clearly without any distracting noise.

Using the baby monitor in the ECO mode helps you to preserve the environment.

Note: The operating range of the baby monitor when it is operated in the ECO mode is 850 feet/260

meters in open air. Depending on the surroundings and other factor that may cause interference, this

range may be smaller.

1 Select ‘ECO mode’ with the + and - buttons (Fig. 33).

2 Press the OK button to conrm (Fig. 34).

3 If the ECO mode is off, the display shows ‘On?’. Press the OK button to switch on the ECO

mode. If the ECO mode is on, the display shows ‘Off?’. Press the OK button to switch off the

ECO mode.

, If you have set the ECO mode to ‘on’, the parent unit switches off and on again. The ECO

mode symbol appears on the display of the baby unit and the parent unit to indicate that

both units now operate in ECO mode.

Note: The connection between parent and baby unit may be lost when the ECO mode is switched on. If

this happens, the operating range may be too large for the ECO mode. In this case, either reduce the

operating range or switch off the ECO mode.

Nightlight on/off

1 Select ‘Light’ with the + and - buttons (Fig. 33).

2 Press the OK button to conrm.

ENGLISH16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

No comments

Philips SCD570/10 User Manual Page 16