Philips SCD570/10 User Manual download pdf (Page 23)

Question Answer

Why does the LINK

light on the parent unit

light up red

continuously and why is

the message ‘Searching’

shown on the display?

The baby unit and the parent unit are out of range of each other. Move

the parent unit closer to the baby unit.

The baby unit may be switched off. Switch on the baby unit.

The ECO mode is switched on, but the operating range is too large.

Move the parent unit closer to the baby unit or switch off the ECO

mode.

Why does the battery

symbol ash on the

display of the baby unit?

The non-rechargeable batteries of the baby unit are running low.

Replace the non-rechargeable batteries or connect the baby unit to a

power outlet (see chapter ‘Preparing for use’).

Why does the parent

unit beep?

If the parent unit beeps while the LINK light lights up red continuously

and the message ‘Searching’ is shown on the display, the connection with

the baby unit is lost. Move the parent unit closer to the baby unit.

If the parent unit beeps and the battery symbol on the display is

empty, the rechargeable battery pack of the parent unit is running low.

Recharge the rechargeable battery pack.

If you have switched off the volume while the sound alert is on, the

parent unit beeps whenever the fourth sound level light lights

up because the baby unit has picked up a sound.

If you have set the room temperature range on the parent unit and the

temperature alert is on, the parent unit beeps when the temperature

drops below the set level or below 57°F (14°C) or when the

temperature rises above the set level or above 86°F (30°C).

The baby unit may be switched off. Switch on the baby unit.

Why does the

appliance produce a

high-pitched noise?

The units may be too close to each other. Make sure the parent unit

and the baby unit are at least 3.5 feet/1 meter away from each other.

The volume of the parent unit may be set too high. Decrease the

volume of the parent unit.

Why don’t I hear a

sound/Why can’t I hear

my baby cry?

The volume of the parent unit may be set too low or may be switched

off. Increase the volume of the parent unit.

The microphone sensitivity level of the baby unit may be set too low.

Set the microphone sensitivity level to a higher level in the menu of the

parent unit.

The baby unit and the parent unit may be out of range of each other.

Reduce the distance between the units.

Why does the parent

unit react too quickly

to other sounds?

The baby unit also picks up other sounds than those of your baby. Move

the baby unit closer to the baby (but observe the minimum distance

of 3.5 feet/1 meter).

ENGLISH 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Comments to this Manuals

No comments

Philips SCD570/10 User Manual Page 23

Comments to this Manuals

Related products and manuals for Baby video monitors Philips SCD570/10