Philips AC1215/10 User Manual download pdf (Page 11)

Cleaning the pre-lter

Clean the pre-filter when F0 is displayed

on the screen (Fig.v).

1 Switch off the air purifier and

unplug from the wall outlet.

2 Pull the bottom part of the front

panel and then gently lift to remove

it from the air purifier (Fig.c).

3 Press the clip down (1) and pull the

pre-filter towards you (2) (Fig.d).

4 If the pre-filter is very dirty, use a

soft brush to brush away the dust.

Then wash the pre-filter under

running tap water (Fig.w).

5 Allow the pre-filter to air dry

thoroughly before placing back in

the air purifier.

Note

• To optimize the lifetime of the pre-

filter, make sure it dries completely

after cleaning.

• Wash your hands after handling the

filter.

6 Put the pre-filter back into the air

purifier (Fig.k).

Note

• Make sure the side with the clip is

pointing towards you, and that all

hooks of the pre-filter are properly

attached to the air purifier.

7 To reattach the front panel, press

the top part of the panel onto the

top of the air purifier (1). Then,

gently push the panel against the

body of the air purifier (2) (Fig.l).

8 Put the plug of the air purifier in the

electrical outlet.

Cleaning the air quality

sensor

Clean the air quality sensor every

2 months for optimal functioning of the

purifier.

Note

• If the air purifier is used in a dusty

environment, it may need to be

cleaned more often.

• If the humidity level in the room

is very high, condensation may

develop on the air quality sensor

and the air quality light may

indicate a more poor air quality

even though the air quality is

actually good. If this occurs, clean

the air quality sensor or use the air

purifier on a manual speed setting.

1 Switch off the air purifier and

unplug from the wall outlet.

2 Clean the air quality sensor inlet

and outlet with a soft brush (Fig.r).

3 Remove the air quality sensor cover

(Fig.s).

4 Clean the air quality sensor, the

dust inlet and the dust outlet with a

damp cotton swab (Fig.t).

5 Dry all parts thoroughly with a dry

cotton swab.

6 Reattach the air quality sensor

cover (Fig.u).

Note

• Always keep air quality sensor

cover close during the air purifier is

working.

9EN

English

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 77 78

Comments to this Manuals

No comments