Philips FR999 User Manual download pdf (Page 23)

TUNER

Tuning to radio stations

Storing radio stations

You can search for radio stations by scanning the frequency

band. You can also key in the frequency of a known radio

station. If an FM station is being broadcast and received in

stereo, STEREO is shown.

Searching for radio stations

1 Turn SOURCE SELECT to select the tuner.

-►TUWCf? is displayed.

2 Select a waveband by pressing TUNER BAND repeatedly.

-►The selected waveband is displayed.

3 Keep ◄ or ► pressed for approximately 1 second.

-►5ERRCH is displayed and the tuner tunes to a station

with sufficient strength.

4 Repeat this procedure until you find the desired station.

• To fine tune to a weak transmitter, briefly press ◄ or ► as

often as necessary for optimum reception.

Tuning to a radio station by frequency (with the remote

control only)

1 Press TUNER.

-►TUNER is displayed.

2 Press FR. D..

-►_ is displayed.

3 Use 1-0 to enter the frequency of a radio station.

Notes: Only valid numbers within the frequency range of the

tuner can be entered.

Switching FM sensitivity

You can switch the tuner to a lower search sensitivity to

search only for stations with a strong signal (FM only).

1 Turn SOURCE SELECT to select the tuner.

-►TUNER is displayed.

2 Press SENS, on the receiver.

-►Either SENS HI or sens lo is displayed for 5 seconds.

Note: While searching for radio stations, the actual sensitivity

is displayed. In this case, sens lo means the tuner is

looking only for radio stations with a strong signal.

You may store up to 30 radio stations in the memory. The

receiver can select and program radio stations by itself or you

can choose them yourself.

Automatic programming

1 Choose * TUNER from the menu and press NEXT ►.

2 Choose nUTEI INSTRUL and press NEXT ►.

-►The preset number where programming will start, the

waveband, and RUTD are displayed.

3 Turn TUNER PRESET ^ to change the preset number where

programming should start.

4 Use TUNER BAND to switch to the desired waveband.

5 Press ENTER / OK to start programming.

►RUTD iTRLL flashes and all available radio

stations are programmed. This may take a few minutes.

Programming is done when RUTD

flashing.

ТП TMCIT

RLL stops

Manual programming

1 Choose * TUNER from the menu and press NEXT ►.

2 Choose NRN IN5TRLL and press NEXT ►.

-►A preset number, the waveband, and the frequency are

displayed.

3 Turn TUNER PRESET ^ to change to the preset number

where the radio station should be stored.

4 Tune to the desired radio station (see "Searching for radio

stations").

5 Press ENTER / OK to confirm your selection.

-►5TDREIJ is displayed briefly. The radio station is

programmed at the chosen preset number.

6 Select and store all desired radio stations this way.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 83 84

Comments to this Manuals

No comments

Philips FR999 User Manual Page 23

Comments to this Manuals

Related products and manuals for Acoustics Philips FR999