Philips MCD703-37 User Manual download pdf (Page 12)

12

English

Connections

Connecting antennas

Connect the supplied AM antenna and FM

antenna to the respective terminals. Adjust the

position of the antenna for optimal reception.

AM Indoor Antenna

1

2

● Position the antenna as far as possible from a TV,

VCR or other radiation source.

FM Indoor Antenna

● For better FM stereo reception, connect an

outdoor FM antenna to the FM AERIAL (FM

ANTENNA) terminal.

Connecting the control cable

Connect the serial port marked “CONTROL

CABLE” at the rear of the DVD player to the

same port at the rear of the power amplifier

with the supplied flat control cable.

Connecting a TV

You must connect a TV to your DVD micro

system in order to view the DVD/VCD playback.

IMPORTANT!

– There are various ways to connect the

system to a TV. You only need to make

one of the best connections, depending

on the capabilities of your TV system.

– If COMPOMENT video output jacks

or S-Video jack is used for video

connection, the system’s Component

setting will need to be set accordingly.

Details are shown under “Video Setup

Page”.

● Connect the VIDEO OUTPUT jack to the

video input jack on the TV using a video cable

(yellow).

OR

Option 1

Connect the S-VIDEO output jack to the S-

Video input jack on the TV using an S-Video

cable (not supplied).

OR

Option 2

Use the component video cables (red/blue/

green) to connect the DVD micro system’s

COMPONENT video output jacks to the

corresponding component video input jacks (or

labeled as Pr/Cr Pb/Cb Y or YUV) on the TV.

IMPORTANT!

– The progressive scan video quality is

only possible when using Y Pb Pr and a

progressive scan TV is required. (Proceed

to page 17-18 for detailed Progressive

Scan setup.)

Option 1

Option 2

Note:

–To avoid magnetic interference, do not position

the front speakers too close to your TV.

pg001-038_MCD703_37_Eng 2006.2.14, 11:0712

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Comments to this Manuals

No comments