Philips STU909 User Manual download pdf (Page 18)

Installation of Satellite

Programmes

This section describes how to select and store new satellite programmes, and

how existing programmes can be changed or deleted.

The STD 909 can receive D2-MAC as well as PAL satellite signals. Generally

the system selection is performed automatically. The 'Sound preference’

menus are different for D2-MAC and PAL.

Note:

In the INSTALL mode it is always possible to remove the menus temporarily

from the screen:

O Press the Q) key on the remote control.

> The menu disappears temorarily from the screen (3 sec).

O Press key MENU

> The MAIN MENU menu appears on the screen

O Select INSTALLATION

l> The INSTALLATION menu appears on the screen

1> Lamp ON flashes green

Note:

It is assumed that the dishes and satellites are installed and that you have

selected the correct satellite antenna input 1 or 2 under SELECT SATELLITE

POSITIONS. If not, first follow the instructions in sections 6, 7, 8 and 9.

O Press 4.

C> The PROGRAMMES menu appears on the screen.

With this menu on the screen you can select all installed satellites with the

help of the <— Î —> keys on your remote control (only for two dish

antennae or rotatable dish).

With the help of the Pv^\ keys on the remote control, you can select all the

programmes from the selected satellite.

O Press 1.

> The FIND PROGRAMMES menu appears on the screen.

O Press 1 and using - or + select the LNC band used:

I - Low band (14 V).

II- High band (18 V)

Note:

Band selection is only possible when a Dual-band LNC is present and

selected in the configuration menu. (See section 6)

O Press 2 (or 1 if dual-band LNC is ‘NO’).

I> The POLARIZER SETTINGS menu appears on the screen.

O Select the polarisation required by pressing 1 to 4.

O Fine-tune (skew) the polarisation using - or +.

I> The signal strength indicator helps your to find the maximum signal strength.

O Press MENU.

INSTALLATION

1 MENU LANGUAOE

2 CONFIGURATION

3 SELECT SATELLITE POSITIONS

4 SELECT PROGRAMMES

5 TXT PREFERENCE PAGES

6 SETCLOCK

select: 1 « 6, off

PROGRAMMES

1 FIND PROGRAMMES

2 PROGRAMME LIST

3 SOUND PREFERENCE

4 STORE

select: 1 >4, menu, off

FIND PROGRAMMES

1 LNC FREQ. BAND ^

2 POLARIZATION SETTINGS

3 SEARCH 1 055 GHZ

4 DIRECT FREQUENCY ENTRY

5 SYSTEM >02MAC<

6 DESCRAMBLER SETTINGS

select: 1 » 6, +. menu, oil

POLARIZER SETTINGS

S1GNALSTENGTH;212

POLARIZAnON : 53

_________

1 HORIZONTAL

2 VERTICAL

SLEPT HAND CIRCULAR

4 RIGHT HAND CIRCUUR

select: 1 • 4, ♦, menu, off

Note:

In case you are using a magnetic polarizer, you might need to adjust the

polarizer settings (‘skew’) for each programme,

or:

In case you have a 14V/18V polarizer:

Select HORIZONTAL or VERTICAL by using - or +.

Search:

Press 3 (or 2 if dual-band LNC is ‘NO’).

An automatic search is performed and the scan stops automatically at the first

detected programme.

POLARIZATION

>HORlZONTAL<

+ , menu . off

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Comments to this Manuals

No comments

Philips STU909 User Manual Page 18

Comments to this Manuals

Related products and manuals for Satellite Philips STU909