Register your product and get support atAJ3270DEN User manual
Select alarm source.• 3 Get started Always follow the instructions in this chapter in sequence. Install battery Warning Risk of expl
Connect power D Caution Risk of product damage! Ensure that the power voltage corresponds •to the voltage printed on the back or underside of the
Compatible iPhone/iPod The clock radio supports these iPod and iPhone models: Made for. iPod touch (1st, 2nd, 3rd, and 4th generation)• i
Charge the iPhone/iPod When the clock radio is connected to power, the docked iPhone/iPod starts charging. Adjust volume G 5 Listen to F
The clock radio stores all the available FM radio stations and »broadcasts the fi rst available station automatically. Store FM radio stat
Note Make sure that you have set the clock correctly. • 1 Press and hold AL1 / AL2 for 2 seconds to enter alarm setting mode. The hour and m
To stop alarm, press the corresponding • AL1 / AL2 . The alarm repeats ringing for the next day. • Snooze alarm When alarm sound
7 Product information Note Product information is subject to change without prior notice. • Specifi cations Amplifi er Rated Output Power 2
General information AC Power Model: AS100-050-AE200; Input: 100-240 V ~, 50/60Hz, 0.5A; Output: 5 V 2.0A Operation Power Consumption <10
Disconnect and reconnect the AC power plug, then turn on the •unit again. Poor radio reception Increase the distance between the unit and your
jkeghfcdbanmliA
this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform y
2011 Koninklijke Philips Electronics N.V.All rights reserved.AJ3270D_12_UM_V1.0
VOL +/-FG
aRADIObTUNING +/-HRHRPMFMHI
EN1 Important Safety Read these instructions.• Heed all warnings.• Follow all instructions.• Do not block any ventilation opening
Where the MAINS plug or an appliance coupler is used as the • disconnect device, the disconnect device shall remain readily operable. 2 Y
Tune to radio stations.• c MIN/PRESET +/- Set minute.• Select a preset radio station.• d Display panel Show current info
Comments to this Manuals