Philips QG3270-41 User Manual download pdf (Page 11)

Cleaning

I Clean the attachments after each use.

I Always switch Groomer OFF, unplug

and remove power supply cord from

Groomer before cleaning.

I Do not use compressed air, abrasive cleaning

agents, scourers or liquids such as alcohol,

benzene, bleach or acetone to clean the

Groomer and attachments.

I Never clean, replace or remove Groomer

attachments with motor ON.

► Do not apply pressure to cutters.

I Do not touch cutters with hard objects as this

may damage them.

During Use:

I If cut hairs have accumulated in the comb

area, remove hairs by shaking, blowing or using

cleaning brush provided. Remember to adjust

the trimming length back to your selected set

ting when you replace the comb on Groomer.

After Each Use:

n Make sure the Groomer is switched OFF

and disconnected from the electrical outlet.

□ Remove any comb or attachment.

u Blow and/or shake out any hair that may

have accumulated in the comb or attachment.

Q Clean the combs, attachments and appliance

with the supplied cleaning brush or a dry,

soft cloth.

B Place the attachment back on the Groomer

handle.

Cleaning the Mini Shaver

H Separate the top part of the mini shaver

from the bottom part (fig. 24).

B Blow and/or shake out any hair that may

have accumulated inside the mini shaver

(fig. 25).

B Clean the top part of the mini shaver under

warm tap water (fig. 26) or with the cleaning

brush.

I The shaving foil is very delicate and should not

be handled.

I If foil becomes damaged, do not continue using

the mini shaver. Do not apply pressure to

shaving foil.

I Do not clean the foil with the supplied brush,

as this may cause damage.

D Shake excess water from mini shaver and

allow to dry thoroughly.

Do not use a towel to dry the mini shaver as

damage to the shaving foil could occur

This Groomer has no other user-serviceable

parts. For assistance call I -800-243-3050.

1 2 ... 6 7 8 9 10 11 12 13

^NORELCO 1
I Trimming nape of neck 9

Comments to this Manuals

No comments