Philips QC5345-15 User Manual download pdf (Page 7)

Assistance

For assistance, visit our website:

www.philips.com/support

or call toll free: 1-800-243-3050

Information is available 24 hours a day,

7 days a week.

Storage

I Be sure Clipper is turned OFF. Remove cord

from outlet and Clipper before storing in a

safe, dry location where it will not be crushed,

banged, or subject to damage.

I Do not wrap cord around Clipper when

storing.

I Store cord in a safe location where it will not

be cut or damaged.

I Do not place or store Clipper where

it can fall or be pulled into a tub or sink, water

or other liquid while plugged in.

Battery Removal

I This Philips Norelco Clipper contains a

rechargeable Lithium-Ion battery

which must be disposed of properly (fig. 13).

I Battery should only be removed when

Clipper is to be discarded.

► For assistance, visit our website:

www.philips.com/support or

call toll free: 1-800-243-3050

D Unplug electrical cord from outlet and

Clipper before dismantling Clipper.

B Allow Clipper to run until the battery is

empty/depleted.

H Turn Clipper OFF.

□ Remove any comb and clipping attachment

from the handle.

B Check if there are any screws in the back or

front of the appliance. If so, remove them.

□ Remove the back and/or front panel of the

appliance with a screwdriver. If necessary,

also remove additional screws and/or parts

until you see the printed circuit board with

the rechargeable batteries.

B IF necessary, cut the wires to separate the

printed circuit board and the rechargeable

batteries from the appliance.

□ Do not attempt to replace battery. Insulate

battery ends by covering with tape and/or

place battery in a small plastic bag.

B Discard your Clipper. Do not attempt to

plug electrical cord into the outlet or

recharge the Clipper after the battery has

been removed.

EE Contact your local town or city officials

for battery disposal information or call

1-800-8-BATTERY or

www.rbrc.com for

battery drop-off locations.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments