Philips FC8810/01 User Manual download pdf (Page 21)

3 Slide the back cover onto the invisible wall again.

Positioning the invisible wall to stop the robot

You can use the invisible wall to prevent the robot from entering a room or

area that you want to keep it out of.

Place the unit at a point you do not want the robot to cross, e.g at an

open door to a room that is off-limits to the robot.

2 Switch on the invisible wall with the on/off slide on top of the unit.

3 Start the robot.

4 When the robot comes too close to the invisible wall, the light on the

invisible wall starts flashing and the invisible wall emits a beam of

infrared light. This beam of infrared light makes the robot change its

course and move away from the invisible wall.

Note: If you use the invisible wall, regularly check if the batteries still contain

sufficient power. You can check this by switching the virtual wall off and on

again. If there is enough energy in the batteries, the LED on the invisible wall

will light up briefly.

Cleaning and maintenance

Cleaning the robot

To maintain good cleaning performance, you have to clean the drop-off

sensors, the wheels, the side brushes and the suction opening from time to

time.

1 Make sure that the power switch is in 'off' position.

2 Place the robot upside down on a flat surface

English

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 193 194

No comments

Philips FC8810/01 User Manual Page 21