Philips GC8260/02 User Manual download pdf (Page 17)

Problem Cause Solution

The iron does not

produce enough

steam/the amount

of steam decreases

and increases during

steam ironing.

When the appliance pumps water into

the steam generator, the steam amount

sometimes decreases. This is probably

when you think that the iron does not

produce enough steam. However, this is

a normal phenomenon and the steam

output normalises within a few seconds.

To optimise the steam output,

release the steam lock when you do

not need steam and when you put

down the iron.

Wet spots appear

on the fabric during

ironing.

The wet spots that appear on the fabric

after you have steam ironed for some

time may be caused by steam that has

condensed onto the ironing board. Iron

the wet spots without steam for some

time to dry them. If the underside of the

ironing board is wet, wipe it with a piece

of dry cloth.

To prevent steam from condensing

onto the ironing board, use an

ironing board with a wire mesh top.

GC8325/GC8320/

GC8261/GC8260/

GC8225/GC8220

only: Water droplets

come out of the

soleplate when I use

the shot-of-steam

function.

Steam may have condensed in the hose,

the temperature may have been set

below 3 or the appliance may not be

ready for steam ironing.

Make sure the temperature is set to

3 or higher. Steam iron for a few

seconds before you use the shot-of-

steam function.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 77 78

Comments to this Manuals

No comments