Philips HB554 User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7

The lamps of the appliance contain substances that may pollute the environment. When you discard the lamps, do not throw them away
with the normal household waste, but dispose of them at an ofcial collection point.
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an ofcial collection point for
recycling. (Fig. 22)

If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer
Care Centre in your country (you nd its phone number in the worldwide guarantee leaet). If there is no Customer Care Centre in your
country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
Guarantee restrictions
The following parts are not covered by the terms of the international guarantee:
tanning lamps
acrylic sheet
cleaning costs of the acrylic sheet

If problems should arise with this appliance and you are unable to solve them with the information below, please contact the nearest Philips
service centre or the Philips Customer Care Centre in your country.
Problem Solution
The appliance does not start. Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by connecting another appliance.
The timer may not have been set. Set the timer to the appropriate tanning time.
The lamp of the face tanner (HB556 only) may still be too warm to restart. Let the lamp cool
down for 3 minutes before you switch it on again.
The fuse of the circuit to which the
appliance is connected cuts off the power
when you switch on the appliance or
when it is in use.
The fuse of the circuit to which the tanning appliance is connected must be a 16A standard fuse
(in the UK 13A fuse)or a slow-blow automatic fuse. You may also have connected too many
appliances to the same circuit.
Poor tanning results Perhaps you use an extension cord that is too long or does not have the correct current rating.
Consult your dealer. Our general advice is not to use an extension cord.
You may have followed a tanning course that is not appropriate for your skin type. Check the
table in section ‘Tanning sessions: how often and how long?’.
Perhaps the distance between the lamps and your body is larger than prescribed.
When you have used the lamps for a long time, their tanning capacity decreases. This effect only
becomes noticeable after several years.To solve this problem, select a slightly longer tanning time
or have the lamps replaced.
-
-
-
-
-
ENGLISH8
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 87 88

Comments to this Manuals

No comments