Philips REM400 User Manual download pdf (Page 5)

5

Philips/Magnavox Components

The DSS remote control can control up to six

different components and is already pre-pro-

grammed for use with newer Philips/

Magnavox audio/video equipment. Unless

you want to change a factory setting,skip the

programming instructions and simply start

using your new remote control.

Programming Other Components

To control component brands other than

Philips/Magnavox,you’ll need to perform the

following steps to manually program the

DSS with codes listed under Manufacturer’s

Codes on pages 15 through 19.Or as alterna-

tive, you can use the Auto Scan feature, on

page 6,to program your component codes.

The following chart lists the remote control’s

component keys and what type of device

each key will control:

Key Programmed To Control

TV TV

VCR VCR, DVD or LD Player

CBL Cable Box

AUD Amplifier, Tuner, Misc.Audio,

or CD Player

DSS Digital Satellite System

CD CD Player,Amplifier, Tuner,or

Misc.Audio

NOTE: If you want the component keys to

control other types of devices, you’ll need to

reassign the component keys. See page 7.

IMPORTANT: Please completely read and

review the following steps before proceeding.We

recommend highlighting the codes (starting on

page 15) for the brands you wish to program or

writing them down in the supplied chart.

Setup Codes For My Components

TV

VCR

CBL

DSS

CD

DVD

AUDIO

LD

OTHER

To Manually Program The Remote Control:

NOTE: To program a TV/VCR Combo, skip

these instructions and follow the steps on the

next page.

1. Manually turn on a component

(e.g.,TV, VCR,etc.) and,if applic-

able,insert media (e.g.,cassette).

2. On the remote con-

trol, press a compo-

nent key once (e.g.,

TV,VCR,CBL,AUD, DSS,or CD).

3. Press and hold SET (approx.

5 seconds) until the red light

blinks twice,then release SET.

4. Enter the first four-digit code for

your brand of component. If

performed correctly, the red

light will blink twice.

5. Aim the remote control at the

component and press POWER

once. It should turn off. If it does

not respond, repeat steps 2 and

3, trying each code for your

brand until you find one that

works. If it still does not work,

try using Auto Scan (on page 6)

to program your component.

6. Repeat steps 1 through 5 for each

component you want to program

into the DSS remote control.

NOTES: Press each key within 10 seconds of

the previous entry. Otherwise, the remote con-

trol will exit the programming mode.

If you press

SET

at any time (except during

step 3), the remote control will exit the pro-

gramming mode without saving your entries.

You will have to start with step 1 to begin pro-

gramming again.

PROGRAMMING YOUR REMOTE CONTROL

REM400 Manual Engl 12/28/99 12:01 PM Page 5

1 2 3 4 5 6 7 8 9 10 ... 18 19

Comments to this Manuals

No comments