Philips 65PFL5903/F7 User Manual download pdf (Page 4)

1 Notice

Trademarks are the property of Koninklijke Philips N.V. or

their respective owners.

P&F USA reserves the right to change products at any time

without being obliged to adjust earlier supplies accordingly.

The material in this manual is believed adequate for the

intended use of the system. If the product or its individual

modules or procedures are used for purposes other than

those specified herein, confirmation of their validity and

suitability must be obtained. P&F USA warrants that the

material itself does not infringe any United States patents. No

further warranty is expressed or implied.

P&F USA cannot be held responsible neither for any errors

in the content of this document nor for any problems as a

result of the content in this document. Errors reported to P&F

USA will be adapted and published on the P&F USA support

website as soon as possible.

Pixel characteristics

This LCD product has a high number of color pixels. Although

it has effective pixels of 99.999% or more, black dots or bright

points of light (red, green or blue) may appear constantly on

the screen. This is a structural property of the display (within

common industry standards) and is not a malfunction.

Warranty

No components are user serviceable. Do not open or remove

covers to the inside of the product. Repairs may only be done

by service centers and official repair shops. Failure to do so

shall void any warranty, stated or implied.

Any operation expressly prohibited in this manual, any

adjustments or assembly procedures not recommended or

authorized in this manual shall void the warranty.

Federal communications commission notice

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception, which

can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by

one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced radio or television technician

for help.

Declaration of conformity

Trade name

PHILIPS

Responsible party

P&F USA, Inc.

Model

65PFL5903, 55PFL5903, 50PFL5903

Address

1880 Braselton Hwy, Suite 118 #5012

Lawrenceville, GA 30043 U.S.A.

Telephone number

1 866 202 5960

Modifications

This apparatus may generate or use radio frequency energy.

Changes or modifications to this apparatus may cause

harmful interference.

Any modifications to the apparatus must be approved by

P&F USA.

The user could lose the authority to operate this apparatus

if an unauthorized change or modification is made.

Cables

Connections to this device must be made with shielded

cables with metallic RFI / EMI connector hoods to maintain

compliance with FCC Rules and regulations.

Canadian notice

CAN ICES-3 (B) / NMB-3 (B)

Analog and digital television receiving apparatus, Canada

BETS-7 / NTMR-7.

The following FCC/IC RSS applies to the

wireless LAN adapter included in this product.

FCC caution: Any changes or modifications not expressly

approved by the party responsible for compliance could

void the user’s authority to operate this equipment.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

Country code statement

For product available in the USA market, only channel 1a1 1

can be operated. Selection of other channels is not possible.

To maintain compliance with FCC RF exposure requirements,

use only belt-clips, holsters or similar accessories that do not

contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not

comply with FCC RF exposure requirements and should be

avoided.

This device complies with Part 15 of FCC Rules and Industry

Canada licence-exempt RSS standard(s). Operation is subject

to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of

this device.

5150-5250 MHz band is restricted to indoor operations only.

High-power radars are allocated as primary users (i.e.

priority users) of the bands 5250-5350 MHz and

5650-5850 MHz and that these radars could cause

interference and/or damage to LE-LAN devices.

Compliance with IC requirement RSS-210

A9.4.4

Data transmission is always initiated by software, which is

the passed down through the MAC, through the digital and

analog baseband, and finally to the RF chip. Several special

packets are initiated by the MAC. These are the only ways

the digital baseband portion will turn on the RF transmitter,

which it then turns off at the end of the packet. Therefore,

the transmitter will be on only while one of the

aforementioned packets is being transmitted. In other

words, this device automatically discontinue transmission

in case of either absence of information to transmit or

operational failure.

To obtain a more detailed electronic copy of this User manual or to access live chat support, go to www.philips.com/support

1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments

Philips 65PFL5903/F7 User Manual Page 4

Comments to this Manuals

Related products and manuals for LCD TVs Philips 65PFL5903/F7