Philips MCD295 User Manual download pdf (Page 18)

18

English

Preparations

IMPORTANT!

– Make sure to complete the

preparation procedures before operating

the system.

Step 1: Inserting batteries into

the remote control

1 Open the battery compartment.

2 Place two batteries (Type R06 or AA) in the

compartment with the correct polarity as

indicated by “+” and “–” symbols.

3 Close the cover.

Using the remote control to operate the

system

1 Point the remote control directly

at the remote sensor (iR) on the

front panel.

2 Select the source you wish to

control by pressing one of the

source select buttons on the

remote control (for example

DISC, TUNER).

3 Then select the desired function

(for example 2;, í, ë).

CAUTION!

– Remove batteries if they are

exhausted or will not be used for a long

time.

– Do not use old and new or different

types of batteries in combination.

– Batteries contain chemical substances,

so they should be disposed of properly.

Step 2: Setting the clock

1 Go to Standby mode.

2 Press and hold CLOCK/RDS on the front

panel.

➜ “SET CLOCK” is displayed briefly. Then, the

hour digits flash on the display screen.

3 Turn the VOLUME control on the front panel

or press VOLUME +/- on the remote to set

the hours.

4 Press CLOCK/RDS again.

➜ The minute digits flash on the display screen.

5 Turn the VOLUME control on the front panel

or press VOLUME +/- on the remote to set

the minutes.

6 Press CLOCK/RDS to confirm the clock

setting.

Notes:

– This system only supports 24-hour mode.

– The clock setting will be erased when the system

is disconnected from the power supply.

– The system will exit clock setting mode if no

button is pressed within 30 seconds.

pg001-pg040_MCD295-05-Eng 2006.3.24, 17:2718

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 38 39

Comments to this Manuals

No comments