Philips QG3270-41 User Manual download pdf (Page 8)

Trimming your Beard & Moustache

with Beard & Moustache Comb

D

Put the trimmer on Groomer handle (fig. 14).

You will hear a ‘dick’.

u Slide the beard & moustache comb into

the guiding grooves on both sides of the

handle and push until it‘clicks’ into place

(fig. 15).

Q Press the Hair Length Setting Selector (I)

and slide it to the desired setting (2) (fig. 16).

See Table 2 for settings.

I If you are trimming for the first time, start

by using the comb at the maximum trimming

length setting (23/32 in/18mm) to prevent

accidentally trimming hairs too short. As you

become familiar with the settings, adjust Hair

Length Setting Selector to desired trimming

length. Selector will "click” into position at each

setting.

D Switch the Groomer ON (fig. 8).

H To trim in the most effective way, move

the Groomer against the direction of hair

growth. Make sure the surface of the comb

always stays in contact with the skin.

NOTE: Since all hairs do not grow in the same

direction, you may want to try different trimming

directions (i.e.. upwards, downwards, or acrossl

Practice is best for optimum results.

► If a lot of hair has accumulated in the comb,

remove the comb and blow and/or shake the

hair out of the comb.You can also use the

cleaning brush provided to remove

hair from the comb area.

Table 2. Beard Trimmer

Remaining hair length

(mm)

Remaining hair length

(in.)

2mm 5/64 in

4mm

5/32 in

6mm 1/4 in

8mm

5/16 in

lOmm

13/32 in

12mm

15/32 in

Hmm 9/16 in

16mm

41/64 in

18mm 23/32 in

I REMEMBER: You must reset the hair length

selector back to your desired setting every time

you replace the comb on the appliance

I The remaining hair length corresponds with

the smallest distance between the cutting

blade and the spot where the comb is in contact

with the skin.

1 2 3 4 5 6 7 8 9 10 11 12 13

^NORELCO 1
I Trimming nape of neck 9

Comments to this Manuals

No comments