Philips QC 5099 User Manual download pdf (Page 10)

4 Clean the cutting unit with the brush supplied (Fig. 9).

5 Also clean the inside of the appliance with the brush supplied.

6 Place the lug of the cutting unit into the slot and push the unit back

onto the appliance (‘click’) (Fig. 8).

This appliance does not need any lubrication.

Replacement

A worn or damaged cutting unit should only be replaced with an original

Philips cutting unit.

Push the middle part of the cutting unit upwards with your thumb

until it opens and then pull it off the appliance (Fig. 7).

Place the lug of the new cutting unit into the slot and push the unit

back onto the appliance (‘click’) (Fig. 8).

Environment

Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. (Fig. 10)

The built-in rechargeable battery contains substances that may

pollute the environment. Always remove the battery before you

discard and hand in the appliance at an ofcial collection point.

Dispose of the battery at an ofcial collection point for batteries. If

you have trouble removing the battery, you can also take the

appliance to a Philips service centre. The staff of this centre will

remove the battery for you and will dispose of it in an

environmentally safe way.



Only remove the battery if it is completely empty.

1 Disconnect the appliance from the mains and let the appliance run

until the motor stops.

2 Open and remove the cutting unit (see chapter ‘Cleaning’).

ENGLISH10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 105 106

No comments

Philips QC 5099 User Manual Page 10