Philips CEM5000 User Manual download pdf (Page 13)

14

5 Push the front side of the panel backward

to the main unit a “click” is heard.

Install remote control battery

Caution

Risk of explosion! Keep batteries away from •

heat, sunshine or ﬁre. Never discard batteries

in ﬁre.

Risk of decreased battery life! Never mix

•

different brands or types of batteries.

Risk of product damage! When the remote •

control is not used for long periods, remove

the batteries.

Perchlorate Material - special handling may

•

apply. See www.dtsc.ca.gov/hazardouswaste/

perchlorate.

For ﬁrst-time use:

1 Remove the protective tab to activate the

remote control battery.

To replace the remote control battery:

1 Open the battery compartment.

2 Insert 1 CR2025 battery with correct

polarity (+/-) as indicated.

3 Close the battery compartment.

5 Install the sleeve into the dashboard and

bend the tabs outward to ﬁx the sleeve.

Note

Skip this step if the unit is not ﬁxed by sleeve •

but by supplied screws.

6 Place the supplied rubber cushion over

the end of the mounting bolt.

7 Slide the unit into the dashboard until you

hear a click sound.

8 Reconnect the negative terminal of the

car battery.

Attach the front panel

1 Attach the trim plate to the main unit.

2 Insert the right side of the panel in the

chassis until it is correctly engaged.

3 Push the left side of the panel and point

the left hole at the left pillar.

4 Release the panel to engage the left side.

5mm

EN

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments