Philips SWW1810/27 User Manual download pdf (Page 12)

Select the source on the transmitter

Press the source buttons on the remote

control, transmitter or receiver until you see the

available video from your device.

Tip

•

For information on the LED indicator status, see the

section on ‘LED indicator status of the transmitter’.

LED indicator status of the

transmitter and receiver

Power

LED

Source

LED

Mode and status

Solid

red

Off Standby mode: it is a

power-saving mode

Flashing

blue

Flashing

blue

Start up in progress: It takes

15-20 seconds.

Flashing

blue

Flashing Searching available channels:

It occurs when the link

cannot establish over 80

seconds after initialization.

Solid

blue

Flashing

quickly

On mode but without

input from the source

device

Solid

blue

Flashing

slowly

On mode with

unrecognized video format

Solid

blue

Solid

blue

On mode with recognized

video format

Note

•

If the link is not established after 80 seconds, move the

transmitter, receiver and HDTV closer to each other.

The maximum transmission range is up to 65 feet (19.7

meters).

• If more than one set of Philips Wireless HD AV Connect

is placed in the same room, make sure that the minimum

distance among each one is 6 feet 6 inches (2 meters).

• If using a computer, make sure the video format is

supported before the video is displayed, see the

chapter on ‘Technical data’ for information.

• If using a computer, and the picture on your TV is

not full screen, see the chapter on ‘Frequently asked

questions’ for information.

Activate the wireless link

Switch on the transmitter and receiver

In standby mode, a red power LED displays on

the transmitter and receiver. You can then turn on

the transmitter and receiver in the following ways:

• Press

on the remote control.

» Both the transmitter and receiver are

turned on.

• Press

on the transmitter and receiver.

Establish the link between the

transmitter and receiver

A ashing blue power LED displays until

the signal link between the two units are

established. Normally, it takes around 15-20

seconds for the link to establish successfully.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comments to this Manuals

No comments

Philips SWW1810/27 User Manual Page 12

Comments to this Manuals

Related products and manuals for AV extenders Philips SWW1810/27