Philips FWP750 User Manual download pdf (Page 27)

27

English

3139 115 20621

2 Press CD, TUNER or TAPE to select the

desired source.

● Before setting the timer, make sure the music

source has been prepared.

CD – Load the disc(s). To start from a specific

track, make a program (refer to “CD Operation -

Programming the disc tracks”).

TUNER – tune to the desired radio station.

TAPE – load the prerecorded tape into tape

deck 2.

3 Press à or á on the system repeatedly to set

the hour for the timer to start.

4 Press í or ë on the system repeatedly to set

the minute for the timer to start.

5 Press CLOCK•TIMER to store the start time.

➜ "TIMER ON" will be displayed and followed

by the set timer "XX:XX" and then the selected

source.

➜ TIMER will remain on the display.

● At the preset time, the selected source will play.

To exit without storing the setting

● Press Çon the system.

Notes:

– If CD is the selected source and it is not

available when the preset time is reached, Tuner

will be selected automatically.

– During timer setting, if no button is pressed

within 90 seconds, the system will exit timer setting

mode automatically.

To deactivate the TIMER

● Press TIMER ON/OFF on the remote control.

➜ The display will show "CANCEL" and TIMER

will disappear from the display.

To activate the TIMER

● Press TIMER ON/OFF on the remote control.

➜ The last set timer information will be shown

for a few seconds and TIMER will appear on

the display.

Sleep Timer Setting

The sleep timer enables the system to switch to

Standby mode automatically within a preset

amount of time.

1 Press SLEEP on the remote control repeatedly

to select a preset time.

➜ The selections are as follows (time in

minutes):

15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 …

➜ "SLEEP XX" or "OFF" will be displayed. "XX"

is the time in minutes.

2 When you reach the desired length of time, stop

pressing the SLEEP button.

➜ SLEEP will appear on the display, except for

"OFF" mode.

➜ The Sleep Timer is now set. Before the

system switches to standby mode, a countdown

of 10 seconds will be displayed.

"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"

™ "SLEEP"

While SLEEP mode is activated

To check the remaining length of time

● Press SLEEP once.

To change the preset sleep timer

● Press SLEEP twice.

➜ The display will show the remaining time

followed by the sequence of sleep timer options.

To deactivate the Sleep Timer

● Press SLEEP repeatedly until "OFF" is displayed,

or press the STANDBY ON button.

Clock/Timer

pg 001-031/P750/37-Eng 3/7/01, 4:12 PM27

1 ... 26 27 28 29 30 31

Comments to this Manuals

No comments