Philips DVD855AT User Manual download pdf (Page 13)

Preparing the Remote Control

Insert the batteries into the remote control so you can use it to

operate the DVD video player.

Make sure to match the + and - on the

batteries to the marks inside the battery

compartment.

Close the cover.

Operating with the Remote Control

This section shows you how to use the remote control.

Point the remote control at the

remote sensor on the DVD video

player and press the buttons.

Within about 20 feet

Distance: Within about 20 feet from the front

of the remote sensor

Angle: Within about 30° in each direction

of the front of the remote sensor

* Do not expose the remote sensor of the

DVD video player to a strong light source

such as direct suniight or illumination. If you

do so, you may not be able to operate the

DVD video player with the remote control.

Notes on

m 'fMS

Direct the remote control at the remote sensor of the DVD video

player.

' Do not drop or give the remote control a shock.

' Do not leave the remote control near an extremely hot or humid place.

' Do not spill water or put anything wet on the remote control.

' Do not open the remote control.

Notes o№tteries

Improper use of batteries may cause battery leakage and corrosion. To

operate the remote control correctly, follow the instructions below.

• Do not insert batteries into the remote control in the wrong direction.

• Do not charge, heat, open, or short-circuit the batteries. Do not throw

batteries into a fire.

• Do not leave dead or exhausted batteries in the remote control.

• Do not use different types of batteries together, or mix old and new

batteries.

• If you do not use the remote control for a long period of time, remove

the batteries to avoid possible damage from battery corrosion.

• If the remote control does not function correctly or if the operating

range becomes reduced, replace all batteries with new ones.

• If battery leakage occurs, wipe the battery liquid from the battery

compartment, then insert new batteries.

Built-in Locator of the Remote Control

* •

The remote control lets you know its location by beeping

each time the main power is turned on.

1 Press the POWER ON / STANDBY button on the front

panel of the DVD video player to turn the DVD video

player on.

The remote control beeps so that you can easily locate it.

The remote control should be within about 20 feet from

the DVD video player, not being obstructed.

2 To turn off the beep, press any button on the remote

control.

• Re-execution requires an interval of about thirty seconds.

• The built-in iocator may not work depending on the

condition, (ex. obstructions, direction of the remote control,

etc.)

1 ... 12 13 14 ... 58

Comments to this Manuals

No comments

Philips DVD855AT User Manual Page 13

Comments to this Manuals

Related products and manuals for Video Philips DVD855AT