Philips DCR 2020 User Manual download pdf (Page 27)

Setup

Setup is used to:

• Install channels

• Test signal level and quality

• modify the general settings of your receiver

• check for software updates

• restore the receiver factory settings.

Access to this menu can be protected by Pin Code.

Channels installation

- Select appropriate values for the following:

• Network ID: applicable network ID as indicated

by your operator. See operator booklet for the

right decimal value to be entered for your region.

• Frequency: broadcast frequency predefined or

entered manually as indicated by your operator

(see operator booklet).

• Symbol Rate: predefined or entered manually as

indicated by your operator.

•

Modulation: modulation type predefined or

entered manually as indicated by your operator.

Symbol rate and modulation values should not be

modified unless requested by your operator.

- Press

OK to start scanning for channels.

Signal Test

Signal Test is used to view the signal level and quality for

the frequency defined at installation.

TV Configuration

Select appropriate values for the following:

•

TV Format: 4:3 or 16:9

•

TV aspect ratio: full format, 16:9 Letter Box, 4:3

Center

• TV output signal: CVBS, RGB, or S Video

• TV audio signal: Stereo, Mono, or Dolby Digital.

• VCR Video Output: CVBS or S Video

•

VCR Recor

ding contr

PREP

ARE

RECORD, or RECORD LINK. See chapter More

about recording (VCR or DVD control).

•

Video mode: PAL or SECAM

- Press OK to store the settings.

DCR 2020_indice1 1/09/05 15:26 Page 61

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments

Philips DCR 2020 User Manual Page 27

Comments to this Manuals

Related products and manuals for TV set-top boxes Philips DCR 2020