11
.
etting up the monitor
2. The MultiView selection menu appears.
3E3
6ZDS
2II
3L3
0XOWL9LHZ
3. Press
and then exit automatically.
How to enable MultiView by OSD menu?
Besides pressing the hotkey directly on
the front bezel
, the MultiView function can also
be selected in OSD menu.
1. Press button on the front bezel to
enter OSD Menu Screen.
3L33E3
$XGL
3L
W
U
,QSXW
RORU
3L33E30RGH
3L33E3,QSXW
3L36L]H
6ZDS
3L33RVLWLRQ
2II
3L3
3E3
2.
[PiP / PbP], then press button.
3. PiP / PbP
Mode], then press button.
4. [PiP] or
[PbP]
.
5. Now you can move backward to set the
[PiP / PbP Input], [PiP Size], [PiP Position].,
or [Swap].
6. Press
MultiView in OSD menu
PiP / PbP Mode: There are two modes for
MultiView: [PiP] and [PbP].
[PiP]: Picture in Picture
Open up a sub-window of
another signal source.
B
A
(main)
When the sub source is not
detected:
B
A
(main)
[PbP]: Picture by Picture
Open up a sub-window side-
by-side of another signal
source.
A (main) B
When the sub source is not
detected:
A (main) B
Note
The black strip shows on the top and the
bottom of the screen for the correct aspect
ratio when in the PbP mode.
PiP / PbP Input: There are four different
video input to choose as the sub display
source: [DVI], [HDMI 1], [HDMI 2], and
[DisplayPort].
Please refer below table for compatibility of
main/sub input source.
SUB SOURCE POSSIBILITY (xl)
Inputs
DP DVI HDMI 1 HDMI 2
MAIN
SOURCE
(xl)
DP
DVI
HDMI 1
HDMI 2
Comments to this Manuals