Philips FWM372 User Manual download pdf (Page 12)

12

English

Basic Functions

IMPORTANT!

Before you operate the system, complete

the preparation procedures.

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available

RDS stations and radio stations automatically.

First time setup/power up

1 When you turn on the main supply, "AUTO

INSTALL - PRESS PLAY" is displayed.

2 PressÉÅ on the system to start installation.

➜ "PLUG AND PLAY" .... "INSTALL" is

displayed, followed by "TUNER" and "AUTO".

➜ PROG starts flashing.

➜ The system will automatically store the radio

stations with sufficient signal strength, starting

from all RDS stations and followed by FM and

MW bands respectively. Weak RDS stations may

be stored in later presets.

➜ When all the available radio stations are

stored or the memory for 40 presets are used,

the last preset radio station (or the first available

RDS station) will be played.

3 The system will proceed to set the RDS clock if

the first preset is an RDS station.

➜ "INSTALL" is displayed, followed by "TIME"

and "SEARCH RDS TIME".

➜ When RDS time is read, "RDS TIME" is

displayed and the current time will be stored.

➜ If RDS station does not transmit RDS time

within 90 seconds, the programme will exit

automatically and the display will show “NO RDS

TIME”.

● If the first preset is non-RDS station;

➜ The programme will exit automatically.

To reinstall Plug and Play

1 In standby or demonstration mode, press and

holdÉÅ on the system until "AUTO INSTALL

- PRESS PLAY" is displayed.

2 PressÉÅ again to start installation.

➜ All previously stored radio stations will be

replaced.

To exit without storing the Plug and Play

● Press Çon the system.

➜ If you do not complete the Plug and Play

installation, the function will be restarted when

you next turn on the main supply again.

Notes:

– When the power is turned on, the disc tray may

open and close to initialise the system.

– If no stereo frequency is detected during Plug

and Play, "CHECK ANTENNA" will be displayed.

– During Plug and Play, if no button is pressed

within 15 seconds, the system will exit Plug and

Play mode.

pg001-pg030_FWM372-22-Eng 2006.3.13, 14:4812

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Comments to this Manuals

No comments