Philips Target Board LPC2138 User Manual download pdf (Page 6)

Jumper & Connector Descriptions

 J1, J2: LCD LED Backlight Polarity: If J1 and J2 is set in position 1-2, then LCD pin15 is connected

to +5V and pin16 is connected to GND. If J1 and J2 is set in position 2-3 then pin15 is connected to

GND and pin16 is connected to +5V. Default set in position 1-2.

 J7: Trace Port Enable: J7 is set to enable pins P1.25:16 to operate as ETM Trace port after reset.

Default not set.

 J8: Debug Port Enable: J8 is set to enable pins P1.31:26 to operate as a JTAG Debug port after reset.

Default is set.

 J9: Debug Mode: J9 selects whether iSYSTEM on-board integrated USB-JTAG debugger is used or an

external debug tool. Default set in position 1-2.*

 J10: RTC Power Supply Selector: J10 connects Vbat pin of LPC2138 to the main 3.3V.

 P11: RTC Power supply: PCB terminal providing connection for battery. When battery power supply

applied to P11 is used, J10 must be open.

 P12: Manufacturing purpose connections

 P13: Analog Output: P13 is analog output from OP amplifier, which connects to output of the DA

converter.

 J15: User LEDs Enable: enables the LED driver connecting the on-board LEDs to GPIO P0.4 – P0.7.

 J16: User Buttons Enable: enables buttons driver connecting the on-board buttons to GPIO P0.12 –

P0.15. Pushing the button generates a low signal. If J16 is set, the CPU will not start in Boot-loader

mode (see J25 description).

 J17: LCD Enable Signal: connects GPIO P0.21 to the LCD enable pin.

 J18: LCD R/W Signal: connects GPIO P0.22 to the LCD R/W pin.

 J19: Analog Output Enable: connects DA converter output (GPIO P0.25) to the OP amplifier.

 J20: Analog Input Enable: connects the TRIM potentiometer to the analog input AD0.0 (GPIO

P0.27).

 P21: 16 Pin LCD Connector: see connectors

 J22: LCD LED Backlight Enable: J22 is set to turn on LCD backlight.

 J25 (bottom side): Startup mode (populated on the bottom side of the target board): J25 connects

either a pull-up (USER mode) or a pull-down (BOOT-loader mode) to P0.14. Default set in position

USER (User mode). J16 must be removed when setting J25 in position BOOT, otherwise J25 setting is

not effective.

*Jumper pin 1 is marked with a white square on the ITLPC2138 PCB. If pin 1 cannot be located directly from

the ITLPC2138, please use Figure 2 for assistance.

Note: Don’t change jumper settings while the target board is supplied with power!

 iSYSTEM, March 2007 6/13

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Philips Target Board LPC2138 User Manual Page 6