Philips PPX4150A/INT User Manual download pdf (Page 4)

4 Philips · PPX 4150

1 General Safety Information

Do not make any changes or settings that are not

described in this user manual. Physical injury or damage

to the device or loss of data can result from improper

handling. Take note of all warning and safety notes indi

cated.

Setting up the Device

The unit is for indoor use only. The device should be

placed securely on a stable, flat surface. Position all

cables in such a way that no one will stumble on them,

thus avoiding possible injuries to persons or damage to

the device itself.

Do not plug in the device in moist rooms. Never touch

the mains cable or the mains connection with wet

hands.

The device must have sufficient ventilation and may not

be covered. Do not put your device in closed cabinets

or boxes.

Do not place the machine on soft surfaces such as table-

cloths or carpets and do not cover the ventilation slits.

Otherwise the device could overheat or catch fire.

Protect the device against direct sunlight, heat, large

temperature fluctuations and moisture. Do not place

the device in the vicinity of heaters or air conditioners.

Observe the information on temperature and humidity

in the technical data.

When the device is running for a long period of time,

the surface becomes hot and a warning symbol appears

on the projection. The device switches automatically to

stand-by mode when it gets too hot. After the device

has cooled down, you can continue playback by pressing

any key.

Do not allow liquids to enter into the device. Switch off

the device and disconnect it from the mains supply if liq

uids or foreign substances end up inside the device.

Have the unit inspected by a technical service depart

ment.

Always handle the unit with care. Avoid touching the

lens. Never place heavy or sharp objects on the projec

tor or the power cable.

If the projector gets too hot or emits smoke, shut it

down immediately and unplug the power cable. Arrange

for your device to be investigated by a technical service

centre. To prevent the spread of fire, open flames

should be kept away from the device.

Under the following conditions, a layer of moisture can

appear inside the device which can lead to malfunctions:

• if the device is moved from a cold to a warm

area;

• after a cold room is heated;

• when this device is placed in a damp room.

Proceed as follows to avoid any moisture build-up:

1 Seal this device in a plastic bag before moving it to

another room, in order for it to adapt to room con

ditions.

2 Wait one to two hours before you take the device

out of the plastic bag.

The device should not be used in a very dusty environ-

ment. Dust particles and other foreign objects may

damage the unit.

Do not expose the device to extreme vibrations. It may

damage the internal components.

Do not allow children to handle the device without

supervision. The packing materials should be kept out of

the hands of children.

Power Supply

Use only the enclosed power adapter (see chapter

Appendix / Technical Data). Check whether the mains

voltage of the power supply matches the mains voltage

available at the setup location. This equipment complies

with the voltage type specified on the unit.

The capacity of the battery diminishes with time. If the

device functions only with the power supply, the battery

is defective. Contact an authorised service centre to

replace the battery.

Do not try to replace the battery yourself. Incorrect

handling of the battery or using the wrong type of bat

tery can cause damage to the device or cause injury.

Switch the device on or off using the power switch

before removing the power supply from the socket.

Turn off the device and remove it from the power sup-

ply before cleaning the surface. Use a soft, lint-free

cloth. Never use liquid, gaseous or easily flammable

cleansers (sprays, abrasives, polishes, alcohol). Do not

allow any moisture to reach the interior of the device.

DANGER!

Risk of explosion with incorrect type of

batteries

Do not try to replace the battery yourself.

There is a risk of explosion if the incor-

rect battery type is used.

DANGER!

High Power LED

This device is equipped with an high power

LED (Light Emitting Diode), which emits very

bright light. Do not look directly into the pro

jector lens. This could cause eye irritation or

damage.

DANGER!

Danger of hearing damage

Do not use the device over a longer time at

high volume – especially when using head

phones. This could lead to the risks of hearing

damage.

PPX4150_UM_EN_253617510.book Page 4 Vendredi, 6. février 2015 2:49 14

1 2 3 4 5 6 7 8 9 ... 17 18

Comments to this Manuals

No comments

Philips PPX4150A/INT User Manual Page 4

Comments to this Manuals

Related products and manuals for Data projectors Philips PPX4150A/INT