Philips CED750/98 User Manual download pdf (Page 2)

English

Connect wires: ISO connectors

Pull out the ISO connectors from the car

dashboard and connect them to the bigger

end of the supplied standard connector.

Connect the other end of supplied standard

connector to the unit.

If necessary, connect the following:•

Connector Connect to/with

Black cable Antenna

Yellow cable Video out 1

Yellow cable Video out 2

Yellow cable Camera in

Green/white

wire

Parking

Black cable Bluetooth microphone

Blue cable Subwoofer

Red cable Front line out L

White cable Front line out R

Red cable Rear line out L

white cable Rear line out R

Mount in the dashboard

Note

Check wire connection before you mount •

the unit into a car.

If preset radio stations are lost when the

•

ignition key is turned OFF and then back

ON, reconnect the red leads crosswise to

the yellow ones.

If the car does not have an on-board drive or

navigation computer, disconnect the negative

terminal of the car battery.

If you disconnect the car battery in •

a car that has an on-board drive or

navigation computer, the computer may

lost its memory.

If the car battery is not disconnected, •

to avoid short-circuit, ensure that bare

wires do not touch each other.

Ensure that car dashboard opening is within

these measurements:

Since the unit cannot be used if the •

dashboard opening’s slant angle is above

20 degrees: Ensure that the horizontal

slant of the car dashboard opening is

between 0 and 20 degrees

Remove the screws on the both side of the

unit.

Remove the mounting sleeve.

Install the sleeve into the dashboard and

bend the tabs outward to ﬁ x the sleeve.

Place the rubber cushion over the end of the

bolt.

Slide the unit into the dashboard until a click

sound is heard.

If the unit cannot ﬁ t into the dashboard, •

remove the mounting bracket on the

both side of the unit and replace them

with the supplied short mounting

brackets.

Attach the trim plate.

Reconnect the negative terminal of the car

battery.

Turn on

1 Press the to turn on the unit.

The screen opens automatically.

The available OSD (On-Screen Display)

languages are displayed.

2 Touch a language to select.

The OSD language is changed to the

selected language immediately.

To adjust the screen tilt, press •

TILT .

To close the screen, press • OPEN/CLOSE .

To adjust the brightness/contrast, press •

/ ,

then adjust 4 WAY NAVIGATION .

To turn off the system, press •

for 3 sec-

onds.

The screen closes automatically.

Set clock

1 Touch to display main menu.

2 Touch [Setting].

The setup menu is displayed.

3 Touch [General].

4 Touch the [Clock mode] repeatedly to

select:

[12hr]• : 12 hour mode

[• 24hr] : 24 hour mode

5 Touch the hour digits, then touch or .

6 Touch the minute digits, then touch or .

7 If 12 hour mode is selected, touch or

to select AM or PM .

8 Touch to exit.

Tune to a radio station

1 Touch to display the main menu.

2 Touch [Radio].

Band and frequency information is

displayed.

3 Touch [Band] repeatedly to select:

FM band options: • FM1, FM2, FM3

AM band options: • AM1, AM2

4 Brieﬂ y touch [Previous] or [Next] to tune

to a radio station by step.

Play discs

1 Insert the disc into the disc slot with label

side facing up.

Play starts automatically.

To remove the disc, press the

button.

When the disc is ejected, the unit switches

to the previous source, if connected. Other-

wise, the unit switches to [Radio] mode auto-

matically.

Insert USB or SD/MMC card

1 Open the USB/SD/MMC card cover.

2 Insert the USB device or SD/MMC card into

the USB socket or SD/MMC card slot.

Play starts automatically.

Pair the Bluetooth-enabled

devices

1 Turn on the Bluetooth function on the

device.

2 Setup the Bluetooth function on your device.

3 Select “CED750” in the pairing list.

4 Enter default password “0000”.

iI pairing succeeds.

[Connect] is displayed

on the panel.

Make a call

1 Pair the phone with the system.

2 Touch to return to main menu.

3 Touch [Bluetooth].

The Bluetooth menu is displayed.

4 Touch to dial.

Receive call

1 If there is incoming call, [Incoming call…]

ﬂ ashes on the screen. Speak into the Blue-

tooth microphone.

2 When conversation ends, touch to

terminate the call.

CED750 QSG_Eng.indd 2CED750 QSG_Eng.indd 2 2008-12-12 16:05:302008-12-12 16:05:30

1 2

Comments to this Manuals

No comments

Philips CED750/98 User Manual Page 2

Comments to this Manuals

Related products and manuals for Car media receivers Philips CED750/98