11
English
Note
Please consult your Phillips dealer or distributer to purchase the CEA100 external
navigation box.
Mount in the dashboard
Note
Check wire connection before you mount the unit into a car.
If preset radio stations are lost when the ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to the yellow ones.
1 If the car does not have an on-board drive or navigation
computer, disconnect the negative terminal of the car battery.
If you disconnect the car battery in a car that has an on-
board drive or navigation computer, the computer may lost
its memory.
If the car battery is not disconnected, to avoid short-circuit,
ensure that bare wires do not touch each other.
2 Ensure that car dashboard opening is within these
measurements:
CEA100
182 mm
112mm
5mm
Connector/Obeject Connect to/with
1 Pink wire Extension wire
2 2.5m extension wire
(Not included)
Parking brake (-)
3 Brake switch
4 Ground
5 ISO wires Connected in step 1 above.
6 Grey wire Rear line out Left/Right
7 Black wire Front line out Left/Right
8 Blue cable Subwoofer
9 Red cable Aux Right
10 White cable Aux Left
11 Yellow cable Video in
12 Yellow cable Camera in
13 Yellow cable Video out 1
14 Yellow cable Video out 2
15 Purple wire Reverse camera (B+)
16 Gearbox switch
17 Reverse gear signal Back lamp lead +
Connect radio antenna
Connect the radio antenna to the radio antenna of the system for
better radio signal.
1 Connect the radio antenna to the car antenna.
Connect external navigation box
This unit supports GPS navigation by connecting Philips CEA100
external GPS navigation box.
EN
Comments to this Manuals