Philips PM2813 User Manual download pdf (Page 78)

5 - 26 Users Manual

Example:

• REQUIREMENTS:

Step automatically throu

h the predefined list of volta

e and current

settin

s, stored at the memory addresses 20 throu

h 40. When the end of

the list is reached, it must be started a

ain at the be

innin

. The next

volta

e and current settin

must be output for channel 1 at an interval time

of 5 seconds.

• SOLUTION:

Send → :LIST:SOUR TIM The next step is automatically initiated by

the internal timer.

Send → :LIST:TIM 5.0 Set the interval time at 5 seconds.

Send → :LIST:SEQ:START 20 Set the start address of the sequence list

at 20.

Send → :LIST:SEQ:STOP 40 Set the stop address of the sequence list

at 40.

Send → :INST:NSEL 1 Select output channel 1.

Send → :OUTP:STAT ON Enable output channel 1.

Send → :INST:STAT ON Make OPERATE mode active.

Send → :INIT:CONT ON Set the CONTINUOUS step function on.

Send → :INIT Initiate the automatic steppin

Check the display of the power supply to verify that the memory address

is automatically incremented every 5 seconds.

Send → :ABORT Exit the automatic steppin

Check that the last recalled volta

e and current settin

remain active.

External step functions

There are three SMB connectors at the rear: START, STEP, and READY.

The modes and functions of the connectors are shown in the followin

table.

NAME MODE FUNCTION

START input Enables steppin

via the STEP input.

STEP input Executes the next step.

READY output Indicates whether a step is finished (ready for

the next step).

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 114 115

Comments to this Manuals

No comments

Philips PM2813 User Manual Page 78

Comments to this Manuals

Related products and manuals for Water pumps Philips PM2813