Philips VRKD11YL99 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 43
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
POWER
CHANNEL
PAUSE
PLAY
STOP
F. FWD
REW
RECORD
VCR/TV
SPEED MENU DISPLAY
EXIT/ C. RESET
COUNTER MEMORY
Turning on Your VCR 11
Before turning on your VCR, make sure there are batteries in
the remote control and the VCR and TV are connected (see
pages five and seven-10).
You can not set up channels if you are using a Cable Box/DBS.
The instructions on this page only work when you turn on the
VCR for the first time. If there is a power failure or if the VCR
is unplugged for more than one minute, you may need to repeat
the instructions on this page.
1
Press the POWER button. The POWER light and the VCR/TV
light will appear on the front of the VCR.
2
Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the VCR. The display shown
below will appear on the TV.
2
1
Turn on the TV. Set it to
channel 3 or 4.
• If you do not see any messages when
you turn on the VCR, check your
hookups, then try again. If you still
do not see any messages, follow the
steps under “Automatic TV Channel
Setup” on page 12 and “Choosing a
Language” on page 16.
• If you try to set up channels when
there is no antenna or cable connect-
ed to the VCR, channel setup will
appear to take place. Eventually,
AUTO SET UP will appear on the
screen steadily, and channel setup
will stop. Connect an antenna or
cable to the ANT(enna) IN jack of
the VCR, then press the MENU but-
ton, the F.FWD button, or the
REW(ind) button again. Channel
setup will begin again.
Helpful Hints
5
Press the MENU button, the F.FWD button, or the
REW(ind) button to begin automatic channel setup.
AUTO SET UP will flash on the screen and channel numbers will
appear in the top right corner of the screen. When channels are
set up, the TV will go to the lowest channel available.
The VCR will memorize all available channels, so when you use
the CHANNEL o/p button, you’ll only scan through channels
that you receive.
3
Press the PLAY button or the STOP button to select
ENGLISH or ESPAÑOL. [ON] will appear beside your choice.
4
Press the F.FWD button or the MENU button. AUTO SET
UP will appear on the screen.
AUTO SET UP
5
3
4
LANGUAGE SELECT
B ENGLISH [ON]
ESPAÑOL
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Comments to this Manuals

No comments