Philips MC77 User Manual download pdf (Page 7)

General Information

This product complies with

the

radio

interference

requirements of the

European

Community:

Environmental information

AH unnecessary packaging has been onnrtted.We

have tried to make the packaging easy to

separate into three materials: cardboard (boji),

polystyrene foam (buffer) and polyethylene (bags,

protective foam sheet).

Your system consists of materials which can be

recycled and reused if disassembled by a

specialised company. Please observe the local

regulations regarding the disposal of packaging

materials, exhausted batteries and old

equipment

Acknowledgement

Energy Star

As an ENERGY STAR®

Partner, Philips has

determined that this product

meets the ENERGY STAR®

guidelines for energy efficiency.

Supplied accessories

- Remote control

- Batteries (two AA size) for remote control

- AM loop antenna

- FM wire antenna

- AC power cord

Safety information

EJefore operating the system, check that the

operating voltage indicated on the lypeplate (or

the voltage indication beside the voltage

selector) of your system is identical with the

voltage of your local power supply, if not please

consult your deafer.

Place the system on a flat hard and stable

surface.

Place the system in a location with adequate

ventilation to prevent internal heat build-up in

your system. Allow at least 10 cm (4 inches)

clearance from the rear and the top of the unit

and 5 cm (2 inches) from each side.

Do not expose the system, batteries or discs to

excessive moisture, rain, sand or heat sources

caused by heating equipment or direct sunlight

If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,

moisture may condense on the lens of the disc

unit inside the system. Should this occur; the CD

piayer would not operate normally. Leave the

power on for about one hour with no disc in the

system until normal playback is possible.

The mechanical parts of the set contain self-

lubricating bearings and must not be oited or

lubricated.

When the system is switched to Standby

mode, it is still consuming some power.

To disconnect the system from the

power supply completely, remove the AC

power plug from the walF socket.

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Comments to this Manuals

No comments