Philips FWR7 User Manual download pdf (Page 10)

INSTALLATION

The type plate is located on the rear of the unit.

1 Check whether the power voltage as shown on the type

plate corresponds to your local power voltage. If it does

not, consult your dealer or service organization.

2 Make sure all connections have been made before

switching on the power supply.

3 Connect the supplied power cable to AC MAINS ~ and to

the power outlet. This switches on the power supply.

For optimal performance use only the original power

cable.

When the unit is switched to standby, it is still consuming

some power. To disconnect the unit from the power

completely, remove the power cable from the power outlet.

To avoid overheating of the set, a safety circuit has

been built in. Therefore, your unit may disconnect

under extreme conditions. If this happens, switch the

unit off and let it cool down before reusing it.

The speaker connections are click-fit connectors. Use them as

shown below.

1 Connect the colored (or marked) wire to the red terminal

and the black (or unmarked) wire to the black terminal.

2 Connect:

– Left speaker to L (red and black)

– Right speaker to R (red and black)

AM antenna

The supplied loop antenna is for indoor use only.

1 Fit the plug of the loop antenna to AM AERIAL as shown

below.

2 Position the antenna as far as possible from a TV, VCR or

other radiation sources.

3 Turn the antenna for optimum reception.

FM antenna

The supplied wire antenna can only be used to receive nearby

stations. For better reception we recommend using a cable

antenna system or an outdoor antenna.

1 Open the FM AERIAL 300 Ω click-fits by pushing the lever

down as shown below.

2 Insert each wire of the antenna into one hole.

3 Close the click-fits using the lever.

4 Move the antenna in different positions for optimum

reception.

The unit complies with the FCC-Rules, Part 15 and with

21 CFR 1040.10. Operation is subject to the following

two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received,

including interference that may cause undesired

operation.

FM AERIAL 300

Ω

FM AERIAL 300

Ω

AM AERIAL

Antenna connections

Speaker connections

Power

English

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Philips FWR7 User Manual Page 10

Comments to this Manuals

Related products and manuals for Video Philips FWR7