Philips FC8796/01 User Manual download pdf (Page 9)

5 You can also press the start/stop button to interrupt or stop the cleaning run. If you press the

start/stop button again and there is still enough energy in the rechargeable battery, the robot

continues cleaning in the auto cleaning mode.

6 To make the robot return to the docking station before the rechargeable battery runs low, press

the docking button on the remote control (Fig. 23).

7 The start/stop button starts flashing and the robot returns to the docking station.

Cleaning mode selection

This robot has four cleaning modes. Its standard cleaning mode is the auto cleaning mode, which is an

automatic sequence of bounce and wall-following patterns (Fig. 24). Next to this auto cleaning mode,

the robot has three individual cleaning modes that can each be activated by pressing the appropriate

button on the remote control.

Bounce mode

In this mode, the robot cleans the room in a mixed pattern of straight and crisscross movements (Fig.

25).

Wall-following mode

In this mode, the robot follows the walls of the room to give the area alongside the walls an extra

clean (Fig. 26).

Spiral mode

In this mode, the robot moves in an expanding spiral from a central point to clean the area thoroughly

(Fig. 27).

Note: The manually selected modes are only active for a couple of minutes. After that, the robot

switches to auto-cleaning mode.

Manual driving

You can drive the robot manually with buttons on the remote control.

1 Use the arrow buttons above and below and to the left and right of the start/stop button on the

remote control to navigate the robot through the room. (Fig. 28)

Note: Be careful when you drive the robot manually close to height differences and staircases.

Using the 24-hour scheduler

The 24-hour scheduler can be activated with the remote control. Make sure the robot is in standby

mode and is placed on the docking station.

1 Press the 24-hour scheduler button (Fig. 29) on the remote control to activate the 24-hour

scheduler.

When you activate the 24-hour scheduler, you hear a sound and the display starts to flash

briefly every few seconds.

The robot will start a cleaning run 24 hours after you activated the 24-hour scheduler. It will

continue to start a cleaning run at the same time every 24 hours until you deactivate the

24-hour scheduler.

2 To deactivate the 24-hour scheduler, press the 24-hour scheduler button. You will hear a sound

and the display will light up continuously to show the robot is in standby mode and the 24-hour

scheduler is no longer active.

English

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 113 114

No comments

Philips FC8796/01 User Manual Page 9