Philips FC8774/01 User Manual download pdf (Page 11)

Signal Meaning

The bumper of the robot is stuck.

A wheel or side brush is stuck.

The top cover is not present or is not closed

properly.

The robot cannot find the docking station.

Clap response

The clap response is enabled when the robot enters sleep mode in the following situations:

when it stops cleaning due to an error

when it cannot find its docking station in 20 minutes

If you do not see the robot, you can locate it by clapping your hands once. The robot will respond by

beeping and by lighting up all icons on its display.

Cleaning and maintenance

Emptying and cleaning the dust container

Empty and clean the dust container when the dust container full indicator lights up continuously.

1 Remove the cover (Fig. 33).

2 Pull up the handle of the dust container lid and lift the dust container out of the dust container

compartment (Fig. 34).

Note: When you remove or reinsert the dust container, take care not to damage the blades of the

motor fan.

3 Carefully lift the lid off the dust container (1) and take out the filter (2) (Fig. 35).

4 Shake the dust container over a dustbin to empty it. Clean the filter and the inside of the dust

container with a cloth or a toothbrush with soft bristles. Also clean the suction opening in the

bottom of the dust container (Fig. 36).

Caution: Do not clean the dust container and the filter with water or in the dishwasher.

5 Put the filter back into the dust container (1). Then place the lid on the dust container(2) (Fig. 37).

6 Put the dust container back into the dust container compartment and put the top cover back on

the robot (Fig. 38).

Caution: Always make sure the filter is present inside the dust container. If you use the robot

without the filter inside the dust container, the motor will be damaged.

Cleaning the robot

To maintain good cleaning performance, you have to clean the drop-off sensors, the wheels, the side

brushes and the suction opening from time to time.

1 Place the robot upside down on a flat surface.

2 Use a brush with soft bristles (e.g. a toothbrush) to remove dust or fluff from the drop-off sensors.

(Fig. 39)

Note: It is important that you clean the drop-off sensors regularly. If the drop-off sensors are dirty,

the robot may fail to detect height differences or staircases.

English

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 129 130

No comments

Philips FC8774/01 User Manual Page 11