Register your product and get support at
CED228
ENG Quick Start Guide
English
Overview of parts
These are the supplierd parts needed to connect and install this unit.
a
c
f
d
e
b
a Carry case with front panel stored inside
b Trim plate
c Standard connector
d Rubber cushion
e Removal keys x 2 pcs
f Screw x 5 pcs
Connect wires: ISO connectors
1
Pull out the ISO connectors from the
car dashboard and connect them to
the bigger end of the supplied standard
connector.
2
Connect the other end of supplied
standard connector to the unit.
3
Do the other connections, if applicable.
Connect wires: without ISO connectors
1
2
3
4
5
6
7
8
1
Cut off the bigger end of the supplied standard connector.
2
Check the car’s wiring carefully, then connect them to the standard connector.
Connector Connect to
1
Black wire A metal surface of the car
First connect the black ground (earth) lead, then connect the
yellow and red power supply leads.
2
Yellow wire The +12V car battery which is live at all times.
3
Orange/white wire Illumination switch
4
Red wire The +12V power terminal which is live in the accessory
(ACC) position of the ignition switch
If there is no accessory position, connect to the +12V car bat-
tery terminal that is always live. Be sure to connect the black
JURXQGHDUWKOHDGWRDPHWDOVXUIDFHRIWKHFDUÀUVW
5
Green and green/black wires Left speaker (Rear)
6
White and white/black wires Left speaker (Front)
7
Gray and gray/black wires Right speaker (Front)
8
Purple and purple/black wires Right speaker (Rear)
3
Connect the supplied standard connector to the unit.
4
Do the other connections, if applicable.
Connect parking brake cable
Connect reverse driving cable
Comments to this Manuals