Philips 7FF2FPAS/00 User Manual download pdf (Page 12)

Banned Substance Declaration

This product comply with RoHs and Philips

BSD (AR17-G04-5010-010) requirements

CE Declaration of Conformity

Philips Consumer Electronics declare under our

responsibility that the product is in conformity

with the following standards

• EN60950-1:2001 (Safety requirement of

Information Technology Equipment)

• EN55022:1998/A1:2001/A2:2003 (Radio

Disturbance

requirement of Information

Technology Equipment)

• EN55024:1998/A1:2001/A2:2003 (Immunity

requirement of

Information Technology

Equipment)

• EN61000-3-2:2006 (Limits for Harmonic

Current Emission)

• EN61000-3-3:1995/A1:2001/A2:2006

(Limitation of Voltage Fluctuation and Flicker)

following provisions of directives applicable

• 2006/95/EC (Low Voltage Directive)

• 2004/108/EC (EMC Directive)

• 2006/95/EC (Amendment of EMC and Low

Voltage Directive) and is produced by a

manufacturing organization on ISO9000 level.

Federal Communications Commission (FCC)

Notice (U.S. Only)

Note:

This equipment has been tested and found to

comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in

a residential installation. This equipment

generates, uses and can radiate radio frequency

energy and, if not installed and used in

accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference

to radio or television reception, which can be

determined by turning the equipment off and

on, the user is encouraged to try to correct the

interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/

TV technician for help.

Caution:

Changes or modifications not expressly

approved by the party responsible for compliance

could void the user’s authority to operate the

equipment.

Connections to this device must be made

with shielded cables with metallic RFI/EMI

connector hoods to maintain compliance with

FCC Rules and Regulations.

To prevent damage which may result in fire or

shock hazard, do not expose this appliance to

rain or excessive moisture.

10

Serwis i gwarancja

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments