Philips HTS7111 User Manual

HTS7111Register your product and get support atwww.philips.com/welcomeEN User manual DA Brugervejledning DE Benutzerhandbuch EL Εγχειρίδιο χρήσης

10Connect to TVConnect your SoundBar to a TV. You can listen to audio from TV programs through your SoundBar. Use the best quality connection availab

11English 2 Using another High Speed HDMI cable, connect the HDMI OUT (ARC) connector on your SoundBar to the HDMI IN or HDMI ARC connector on the T

12Option 2: Connect audio through a digital coaxial cableGood quality audio Using a coaxial cable, connect the COAXIAL connector on your SoundBar to t

13EnglishListen to a connected deviceBefore you can listen to a connected device, select the source for the device.Main unitPress SOURCE on the SoundB

14Sound modeSelect predened sound modes to suit your video or music.1 Press SOUND SETTINGS repeatedly to select MODE on the display panel (see ‘Sound

15EnglishEqualizerChange the high frequency (treble) and low frequency (bass) settings of the SoundBar.Press TREBLE +/- or BASS +/- to change the freq

16EasyLinkThe SoundBar supports Philips EasyLink, which uses the HDMI-CEC (Consumer Electronics Control) protocol. EasyLink-compliant devices that are

17EnglishPlay audio from SoundBarYou need to connect an HDMI-CEC device to the TV and route its audio output from TV to the SoundBar in order to map t

181 Press SETUP repeatedly to cycle through the options on the display panel (see ‘Setup menu options and settings’ on page 18).2 Select an option, a

19English8 Wall mount and standBefore you mount your SoundBar to the wall or onto a single stand, read all safety precautions (see ‘Safety’ on page 5

209 Product specificationsNote •Specications and design are subject to change without notice.Amplier• Total output power: • Europe and Asia: 300W

21English10 TroubleshootingWarning •Risk of electric shock. Never remove the casing of the product. To keep the warranty valid, never try to repair th

22PlayWhen you switch on the TV, the SoundBar automatically switches on.• This behavior is normal when you are using Philips EasyLink (HDMI-CEC). To

© 2011 Koninklijke Philips Electronics N.V.All rights reserved.sgptt_1131/12_v2book1 back page.indd 4book1 back page.indd 4 12/29/2010 3:28:13 P

3English8 Wall mount and stand 19Wall mount 19Stand for SoundBar and TV - STS1100/STS1300 209 Product specications 2010 Troubleshooting 21Conte

42 NoticeThis section contains the legal and trademark notices.Compliance This product is in compliance with the essential requirements and other rele

5English3 ImportantRead and understand all instructions before you use your SoundBar. If damage is caused by failure to follow instructions, the warra

6Care for your product Use only microber cloth to clean the product.Care of the environment Your product is designed and manufactured with high quali

7EnglishRemote control a (Standby-On) • Switch the SoundBar on or to standby.• When EasyLink is enabled, press and hold for at least three seconds

8EasyLink controlsWith Easylink, you can control your SoundBar, TV and the connected devices with the standby button on your SoundBar remote control.•

9EnglishConnectConnect your subwoofer to your SoundBar as described in the quick start guide.SetupSet up your subwoofer through the setup menu.1 Press