Philips DA1102 User Manual download pdf (Page 19)

DA11 Operation

If you have difficulty determining the correct setting, please contact

techsupport@lavryengineering.com once you have the manufacturer’s ratings for your

equipment.

OPTIONAL INFRARED REMOTE

The DA11 is programmed to accept standard Philips RC5 TV infrared remote commands. This

means almost any Universal infrared remote control can be programmed to control the DA11. Be

sure to check the information on the universal remote package to confirm it works with Philips

TV’s. Follow the instructions that come with the universal remote, and program the remote using

the code from the instructions for a Philips TV. If the first code does not work correctly, there is

often more than one code available; so try a different code that is also for a Philips TV.

Once the universal remote is programmed, it controls the DA11 in the following manner:

1.) The “Mute” button is always active and immediately toggles the audio outputs of the DA11

“on” and “off.” Please note that this does affect the headphone output and is therefore not the

same as the “output” function in Settings mode.

- To indicate the “mute” function has been engaged, the two LED’s in the IMAGE display will go

dark unit the mute button is pressed again to un-mute the DA11, or the mute function is turned

“off” by operating the DA11’s front panel volume up/down switch.

2.) All other commands are “gated” to prevent accidental changes unless the SAFE MODE is

disabled. The symbol “LE” appears in the VOLUME display to indicate that the gate is “closed”

and the DA11 will not accept infrared commands other than Mute. Press and hold the number “0”

button for a few seconds, and the numerical volume setting will re-appear to indicate that the

“gate is open.” As long as the numerical volume setting is displayed, the DA11 continues to

accept remote commands. Please also note that the “LE” indicates when the settings have been

stored in memory. See DISABLING SAFE MODE (below) to disable the “gating function.”

- Pressing the “Mute” button also “opens the gate;” so it is not necessary to press “0” to access

the other remote functions until the LE symbol appears in the Volume display.

For all of the following functions, it is assumed that the “gate is open” so the numerical

setting is visible in the VOLUME display or that SAFE MODE has been disabled.

3.) To raise or lower the volume setting, press the Volume Up or Volume Down button on the

remote. Similar to the front panel “up/down” switch, a single press of the remote button will

change the volume by one step, and holding the button will make the setting change continuously

until the button is released or the end of the adjustment range has been reached.

4.) The number pad can be used to adjust the >PiC< Playback Image Control™ and control the

“gating” function according to the following chart:

Increase width Left channel

Increase width both channels

Increase width Right channel

Decrease width Left channel

Decrease width Both channels

Decrease width Right channel

No function

Reset width to “0” (normal)

No function

Press & Hold to open “gate”

1 2 ... 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Philips DA1102 User Manual Page 19

Comments to this Manuals

Related products and manuals for Recorders Philips DA1102