Philips 65PFL8900/F7 User Manual download pdf (Page 10)

Installing the stands

You must support the top of the TV set at all times to prevent the TV from

falling.

Carefully tilt and lay the TV set with the cautionary note on the plastic

bag upward and its rear panel down as shown in the illustration. This

requires two or more people.

supporting point

Remove the center base of the three bottom polystyrene foam

bases.

From the center bottom part, rip the plastic bag to expose the bottom

of the TV set.

plastic bag

Assemble the stand.

2 screws each

required

Insert the support pillars of the stand into the bottom of the TV all the

way to the end of the stand slots.

stand slots

stand slot guides

Carefully raise the TV set as shown in the illustration. This requires two

or more people.

supporting point

Rip the plastic bag to make it easy to tighten screws. Tighten screws.

4 screws

required

Remove the top polystyrene foam base and the plastic bag to

expose the handles.

handles

Note(s)

•

A wide open space is recommended for assembly.

•

A Phillips-head screwdriver is required to fasten the stands to the TV set.

•

When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly

attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•

To remove the stand from this unit, unscrew the Phillips-head screws by reversing the

procedure. Be careful not to drop the stand when you remove it.

10 .English

Continued on next page.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 58 59

No comments

Philips 65PFL8900/F7 User Manual Page 10